Philips 42PF5520D/10 help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • netdent
    Badcaps Veteran
    • May 2011
    • 208

    #1

    Philips 42PF5520D/10 help

    I have this 42 Plasma, it has samsung panel PDP-342SD-YD07

    PSU LJ44-00101CPS

    I replaced a known cap on the psu some time ago which switched the psu on but still no picture, pulled out today to have another go, the y and z boards are humming nicely, at power on you get a brief picture on screen then it dissapears

    I suspect previous owner has been twisting the pots? maybe not, anyway this psu does not show what the voltages should be that I can find, here is what I get

    VE-85v
    VS-190v (this was 207v I turned it down)
    VS scan- minus 175v
    V set- 181v

    If anyone can tell me the correct voltages or recognises the fault please let me know, from what I can see of the picture it looks clear whem on for 1 second

    thanks Ronnie
    sigpic
  • PlainBill
    Badcaps Legend
    • Feb 2009
    • 7034
    • USA

    #2
    Re: Philips 42PF5520D/10 help

    Originally posted by netdent
    I have this 42 Plasma, it has samsung panel PDP-342SD-YD07

    PSU LJ44-00101CPS

    I replaced a known cap on the psu some time ago which switched the psu on but still no picture, pulled out today to have another go, the y and z boards are humming nicely, at power on you get a brief picture on screen then it dissapears

    I suspect previous owner has been twisting the pots? maybe not, anyway this psu does not show what the voltages should be that I can find, here is what I get

    VE-85v
    VS-190v (this was 207v I turned it down)
    VS scan- minus 175v
    V set- 181v

    If anyone can tell me the correct voltages or recognises the fault please let me know, from what I can see of the picture it looks clear whem on for 1 second

    thanks Ronnie
    Usually there is a white label on the panel that shows these voltages. They vary with the individual panel.

    PlainBill
    For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.

    Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.

    Comment

    • netdent
      Badcaps Veteran
      • May 2011
      • 208

      #3
      Re: Philips 42PF5520D/10 help

      Hi Plainbill, I removed the psu and found the info on the underside, everything was pretty much right, but when I refitted the psu the alarm led on the psu is blinking a code related to va, seems to relate bottom buffers? not sure why this would happen

      thanks Ronnie
      sigpic

      Comment

      • PlainBill
        Badcaps Legend
        • Feb 2009
        • 7034
        • USA

        #4
        Re: Philips 42PF5520D/10 help

        Originally posted by netdent
        Hi Plainbill, I removed the psu and found the info on the underside, everything was pretty much right, but when I refitted the psu the alarm led on the psu is blinking a code related to va, seems to relate bottom buffers? not sure why this would happen

        thanks Ronnie
        I'm not sure, either. I'll try to do a little research on this later.

        PlainBill
        For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.

        Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.

        Comment

        • netdent
          Badcaps Veteran
          • May 2011
          • 208

          #5
          Re: Philips 42PF5520D/10 help

          Originally posted by PlainBill
          I'm not sure, either. I'll try to do a little research on this later.

          PlainBill
          Thanks PlainBill, will lay it to the side meantime.

          thanks Ronnie
          sigpic

          Comment

          Related Topics

          Collapse

          • Patrick501
            Philips 55PUS6704 no picture, backlight ok
            by Patrick501
            Hello,
            I'd like to repair a Philips 55PUS6704.
            It turns on and you can see the backlight, hear the sound but no picture.

            When I disconnect one of the T-con cables, half of the screen turns white.
            right cable disconnected= right side white
            left cable disconnected= left side white

            When I tape like 6 or 7 pins of one cable it looks like the picture attached. I already tried another T-con board without success.
            There are no shorts on the the mainbaord and the two lcd panel boards...at leat I couldn't find any.
            Also you can notice one single...
            11-12-2025, 08:46 AM
          • Rauni
            Philips 58PUS7805/12 showed no picture; after T-Con replacement, shows halo
            by Rauni
            Hello, this is my first post on this forum, and my first attempted to repair a TV.

            My Philips 58PUS7805/12 stopped working recently. It is not that old, about 5 years. We were on a trip for a few days and when we came back, it had stopped working out of a blue (Perhaps our house was hit by a lightning strike? Don't know.)

            Read from a guide that I should test if the screen shows picture with one of the T-Con cables disconnected. Did that, it showed perfect picture (first on left, later on right side).

            Read also that we should test what happens if we...
            10-01-2023, 12:06 AM
          • Schwoin
            Philips 243v5lhsb00 Monitor Picture too bright
            by Schwoin
            Hey everyone,

            the picture on my philips monitor looks way too bright so that black appears grey and colors also seem too bright.



            While i tried to tilt the screen a little bit while it was displaying a picture, i´ve noticed, that there appeared some purple pixels. In the following picture
            you can see them on the top half of the photo.



            At a certain point during the tilting, the picture looked normal again but as soon as i laid it back down, the purple pixels were gone and the picture was bright again.
            ...
            03-21-2023, 12:40 PM
          • madyoyo
            Philips 37pfl560: Yellow picture
            by madyoyo
            HI.

            I have a weird problem with an old Philips 37pfl560 TV i put out of storage: the picture have a noticeable yellow hue, and its not caused by the settings (did a factory reset). I've never seen this before. I will try to get a photo with a real camera, with my phone its hard to see because of automatic white balance, but in real live the whites are really yellow.

            Anyone have an idea of what can cause this? Can CCFL tubes get "warmer" with time? This tv have several analog inputs,so its nice for retrogaming....
            05-30-2025, 10:16 AM
          • charlesdutcher
            No picture issue in Philips Chassis FTL2.1
            by charlesdutcher
            Hello,
            My Plasma Philips 37inch chassis FTL2.1 does not show picture. It automatically goes into protection mode after 30 seconds (red led blinks at 3Hz)


            Is there someone having any symptom like this? How to fix it?

            Thanks in advance!​
            08-06-2024, 09:55 PM
          • Loading...
          • No more items.
          Working...