Announcement

Collapse
No announcement yet.

Recaping a motor indexer power board

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Recaping a motor indexer power board

    This unit has a switching power supply which did not have low ESR caps in it
    Which I was surprise to see
    I recapped with low ESR caps I used (LXY) 47uf@50 volts (12) of them

    One 100uf@35 volts (LXY)


    Two 1000uf@250 volts

    And one more I do not remember the value
    I ran it at full speed and seem to like the caps that I put in it
    Last edited by sam_sam_sam; 03-14-2016, 09:39 AM.
    Tags: None
    #2
    Re: Recaping a motor indexer power board

    Good repair job!
    What were the brands/markings on the original units?
    My first choice in quality Japanese electrolytics is Nippon Chemi-Con, which has been in business since 1931... the quality of electronics is dependent on the quality of the electrolytics.

    Comment

      #3
      Re: Recaping a motor indexer power board

      Here are the 47uf @25 volt caps that were in it
      Attached Files
      Last edited by sam_sam_sam; 03-24-2016, 04:04 PM.

      Comment

        #4
        Re: Recaping a motor indexer power board

        Here is some of the caps that were in it
        My phone having real problem on your site
        Loading photos
        Attached Files
        Last edited by sam_sam_sam; 03-24-2016, 04:02 PM.

        Comment

          #5
          Re: Recaping a motor indexer power board

          Bump
          Attached Files
          Last edited by sam_sam_sam; 03-24-2016, 04:07 PM.

          Comment

          Previous template Next
          Working...
          X