Help replacing 4 diodes with rectifier and improving old AT PSU

Collapse
X
Collapse
 
  • Page of 3
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
  • Behemot
    Badcaps Legend
    • Dec 2009
    • 4845
    • CZ
    #41
    Re: Help replacing 4 diodes with rectifier and improving old AT PSU

    You can use halogens only if you put thermistor which lowers the starting current in series with the bulb.
    Less jewellery, more gold into electrotech industry! Half of the computer problems is caused by bad contacts

    Exclusive caps, meters and more!
    Hardware Insights - power supply reviews and more!

      Comment

      Previous 1 2 3 template Next

      Related Topics

      Collapse
      • Dvsr
        On M-Audio AV40 active studio speaker's two zener diodes get really hot.
        by Dvsr
        Hi. I need help from wiser guys. I am amateur in electronics and can't figure this out by myself.
        I bought faulty speakers, M-Audio AV40's. Other speaker has all the electronics in it and the other speaker is just passive one powered by the other speaker's amp. Original problem with the speakers was loud buzzing. I figured out that there is something wrong with the capacitors. I went ahead and replaced every electrolytic capacitor on the PCB. The caps are good quality and have the same values as the original ones.
        After replacing the caps I started testing out the speaker. It seemed...
        4 Photos
        09-10-2025, 10:20 AM
      • _AcE_
        JBL Soundbar 2.1 Deep Bass PSU No DC Power Output (Detailed, w/ Schematics)
        by _AcE_
        I have two of these soundbars, both with the exact same issue. The soundbars were hit by lightning and no longer power on. The PSU does not output any voltage on the DC side. When plugged into mains, the DC output is a stone-cold 0.0 volts. The AC side of the PSU seems to be functioning correctly (as far as I can tell). When checking the plugged-in PSU with my thermal camera, the OB5269CP PWM controller (U1) and the two resistors (R12 and R13) pulse on and off. These run to the positive DC side of the bridge rectifier (among other components along the way).

        There's no physical damage...
        08-10-2025, 09:27 AM
      • caspian
        What Zener Diodes on a Linear Power Supply
        by caspian
        Dear members,

        I have a linear variable power supply with unknown brand name that I used for voltage injection.
        Then it failed. I discovered that its transistors (Q1 and Q2) are shorted.
        In addition, I discovered that its zener diodes are defective.
        I can replace the burned transistors.
        But I do not know the model of the zener diodes. the model number is not marked on the zener diodes.
        Therefore, I cannot replace the zener diodes.
        I do not want to test the zener diodes in a test circuit to discover their model or value.
        no schematics are available...
        05-26-2025, 12:38 PM
      • momaka
        KingWin ABT-650MM 650 Watt ATX PSU [PCB: SW8835REV:A]
        by momaka
        For today's thread, I have a KingWin ABT-650MM ATX PSU. Official web page with the PSU specs is still up and can be found here:
        http://www.rmac.kingwin.com/products.../abt_650MM.asp

        I just can't help it when I see a broken / for parts PSU on eBay that's listed for cheap and looks at least somewhat interesting. Well, OK, I won't lie – on the outside, this PSU looks anything but interesting. It's a plain gray box with colorful “spaghetti cables”.




        What mostly drew me into buying it is its 2x PCI-E power connectors...
        03-29-2022, 11:34 PM
      • momaka
        Casing Power MPT-301 [PCB ATX9806b-p REV: A3]
        by momaka
        This one should make @Pentium4 smile (if he is still reading BCN forums) – I got a new old stock / open box Casing Power MPT-301 PSU on eBay for $4 total.


        Yes, it’s a very generic-looking box, but the manufacturer isn’t (at least not back in the days), which is…

        Macron Power Technology Co. LTD.

        Let’s look at the PSU itself.



        The shell/case also appears quite generic, like many “sold-with-the-PC-case” units. However, the shell is well-formed and has decent steel thickness. In terms of...
        06-02-2021, 10:05 PM
      • Loading...
      • No more items.
      Working...