ocz stealthxstream 600 - capacitor replacement

barrubba

New Member

Join Date: Nov 2012

Posts: 1

Country: italy
#1

ocz stealthxstream 600 - capacitor replacement

11-07-2012, 02:17 PM

after 8 year my supply is not ok!
i boot and the pc swich on and off after 3-4 seconds, in loop.
The cause are 2 capacitor .
how can i see exact cap model? there is a pdf technical drawing or something like that?
any suggestion where to buy caps?
After so many time i hope to keep it on life!
Tags: None
momaka

master hoarder

Join Date: May 2008

Posts: 12164

Country: Bulgaria
#2

11-11-2012, 06:27 PM

Re: ocz stealthxstream 600 - capacitor replacement

Remove the capacitors from the power supply (but make sure to note their location and orientation first), then read the information written on them and post it here.
Comment

Previous template Next

Where can I get compatible capacitor for replacement?

by artvandalai

Blew the capacitor on my analytical balance scale using the wrong power adapter. I need help finding a replacement compatible capacitor to buy. Will any 100uf 40v capacitor work as a replacement?

3 Photos
- Channel: General Capacitor Questions & Issues
12-28-2024, 10:15 AM
klipsch kda-500 amplifier suitable power supply capacitor replacement ?

by r2digital

I have a klipsch kda-500 that would turn on and allow me to get into the web management but it was picking up a lot of noise from audio sources so i decided to replace the smd caps on the power supply along with radial one. Some one was in here before me and they basically burned the bottom side of the traces off for the radial cap but i was able to repair it without any real problem. I thought i did a good job sourcing out replacement caps but apparently not and now i can't get the power supply to turn on it just constantly try's to keep turning on. Attached is a picture of the power supply before...

2 Photos
- Channel: Troubleshooting Power Supplies and Power Supply Design
04-18-2024, 03:50 PM
Discontinued Capacitor looking for Replacement

by rwkish

Capacitor has been discontinued (EGXF101ELL331MM20S) all of the replacements I have found have are smaller than 0.709" Dia (18.00mm). I would like to use the same size or at least close to the same size Capacitor. 19mm would be too big as they would touch and not be able to through hole mount. Tia...
- Channel: General Capacitor Questions & Issues
08-18-2024, 06:54 PM
Replacement capacitor options please?

by Hylax

Hi, I'm super new to this capacitor stuff but I've some basic soldering experience with old cellphones PCBs and headphones. I have this APAQ AR5K 820∆μF 3V Dc Capacitor from a motherboard that I'm looking to replace, photos I've attached. But I'm unable to find a 3V one like I've marked in the spec sheet in red (This is the one currently present in the motherboard). But the 6.3V one I can find (marked in blue) is of similar dimensions but different specs as mentioned in the table. Is it okay to replace it with higher voltage cap, slightly higher ESR, slightly lower ripple current, and double...

3 Photos
- Channel: General Capacitor Questions & Issues
08-09-2024, 11:25 PM
Single capacitor replacement on arcade pcb

by GKdays

I have a damaged capacitor from a bootleg double dragon arcade pcb and I have the normal values from it:

10 volt, 100uF, 85c, but someone from an arcade forum said that the ripple current is not that critical and any good quality low esr cap would be fine, the damaged one is an electrolytic can type but I don't know what to look for as far as low esr is concerned, can a ceramic capacitor be used instead, the capacitor is going to the +5 volt

I don't know the brand but on the top of the capacitor is stamped "76 F6" if there is a datasheet ide be able to...
- Channel: General Capacitor Questions & Issues
08-09-2022, 05:21 AM
Loading...
No more items.

ocz stealthxstream 600 - capacitor replacement

ocz stealthxstream 600 - capacitor replacement

Comment

Related Topics