pcb layer scematic alienware m17 r3 c912p

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • pisvlek
    New Member
    • Sep 2021
    • 2
    • h veld g dam
    #1

    pcb layer scematic alienware m17 r3 c912p

    I have burn out lines around the pq100 mosfet by my mistake cose i left the project for a while and put the power on and burnt it out.
    I have the hole sircuit of that part b+ and 5val searched but there seems to be a short under the mosfet lanes pq100 with ground.
    So i need a pcb layer scematic for my c912p board to no what the lane piece is ground or power for a further search of the short.
    i hope some one can help me out.
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • ResoluteHawk
      Alienware 17 R3 (LA-C912P) Powers on then powers off after 4-6 seconds
      by ResoluteHawk
      I have an Alienware 17 R3 (board is a C912P) that I recently starting trying to repair. Originally the issue was the charger going into protection mode when plugged in to the laptop. I found a short on the motherboard (one of the capacitors on the back of the board under the DRMOSes for the CPU) and the charger when plugged in now doesn't go into protection mode anymore. The laptop powers on, the lights on the keyboard, alien head, and alienware logo light up, and the fans spin. The issues are:

      1) The battery doesn't charge. I've probed the charger jack and it's only receiving 0.633v...
      06-17-2022, 01:04 PM
    • ph st
      Dell Alienware 17 R3 LA-C912P
      by ph st
      Hey guys,

      i do have some troubles with this Mainboard.

      I just got it from my brother after it had some real damage after a huge flood.
      I cleaned everything so far and i try to make it work again.

      The first issue i experienced was that the inductor (as shown) was not completly soldered any more.

      I checked all the other with a multimeter and they seem to work fine.

      As i am not sure what exactly the purpose of this part is, so i am not sure if its damaged and how to check it. I checked the schmematic, but did not get a clue hahaha....
      2 Photos
      12-02-2024, 02:10 PM
    • exerion5000
      DELL Alienware 17 R3 (LA-C912P) only work with 120w charger in mode low CPU clock
      by exerion5000
      Hello, I received this laptop with the following condition: When I turn it on, it shows the ALIENWARE light and the Alien button lights up, then it does not show an image and it restarts constantly, as the customer had already informed me that the battery was dead, I connected an original charger that I had it for testing, the machine turned on normally and I was able to enter Windows without problems, after a while of testing I noticed that it is very slow (like a Cyrix 425...), and after performing a CPU test the frequency is
      below normal, as if it were operating in an extreme energy...
      10-15-2023, 02:12 PM
    • REpairAT
      Alienware 15 R2 LA-C912P no CPU power
      by REpairAT
      Hi,
      Device is Alienware 15 R2
      MB: AAO21 LA-C912P Rev: 1.0(A00)

      Computer beeps 7 times, meaning "CPU failure". CPU stays cold, gets no power at all. No CPU short, resistance around 4Ohms. GPU voltage seems to be ok. Gate driver on top of coils are SIC632 but I have no experience testing them. Attached the picture with measured voltages, I appreciate any form of help.

      Thanks a lot! ...
      09-29-2022, 07:06 AM
    • tech_guru
      Dell Alienware 17 R3 - LA-C912P Motherboard repair - 7 Beeps
      by tech_guru
      Hello.
      I am having a disappointing motherboard repair with this laptop and I need your help.
      This came in with water damage, doing absolutely nothing, and had almost all standby voltages shorted. I have already replaced all those shorted components:
      -UE5 SIO KB9022QD - Programmed spare one, when replaced, 3.3v short got out
      -PQ102 MDV1525URH
      -U17 AOZ1331
      -UE1 C8051F383-GQ
      -PU800 SY8032ABC
      -UI2 SY6288D20AAC
      -PU508 RT6220AHGQUF 7P=
      -PU100 TPS51225CRUKR
      -PU300 TPS51212DSCR

      Now, I get all the standby voltages, it turns...
      02-16-2024, 09:40 AM
    • Loading...
    • No more items.
    Working...