asus x455lj rev 2.1 cannot power on

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • vampy999
    Senior Member
    • Sep 2019
    • 104
    • malaysia
    #1

    asus x455lj rev 2.1 cannot power on

    Hi everyone,

    This board (ASUS x455lj)cannot power on once powered off. But can power on when i short Q3204 pin 3 to ground. Anyone can tell me what problem is this?
    Attached Files
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • PantherDave
      Microsoft Surface Pro (5th gen) model 1796 - no power
      by PantherDave
      Hi all!

      I'm trying to troubleshoot a Microsoft Surface Pro (5th gen) model 1796 that won't power on. Motherboard model is M1007506-015. My priority is retrieving data, but the SSD is integrated so it looks like if I can't repair it it'll need to go to a data recovery company. I've done a little basic board repair before, but nothing this advanced until now. So please forgive my ignorance in advance. 😅

      I found the boardview for this laptop in the forums here, and am able to open it on my PC with FlexBV.
      https://www.badcaps.net/forum/troubl...-hardware-devi...
      05-29-2024, 02:01 PM
    • ShadowAi
      ASUS TUF X570-PLUS doesn't power on: no VRM_EN signal.
      by ShadowAi
      Hello, I have an issue with the motherboard. Specifically, it doesn't power on, more precisely, the POST initialization doesn't occur.

      Let me start from the beginning, the motherboard suddenly stopped working one day. There are no beep signals from the speaker, and the debug LEDs are not lighting up. After inspecting it under a microscope and using thermal imaging, I didn't find anything that could be damaged.

      After that, I began voltage measurements, in which I noticed the absence of VDDQ, VDDP, VTT, and VPP lines. Later, I checked if there is an EN state on these lines,...
      03-15-2024, 10:46 AM
    • meraklinetx
      Asus Z97-a power cycle, no boot no cpu voltage
      by meraklinetx
      Hello, I have an asus Z97-A motherboard and it doesn't start which was working properly before, the problem isn't related by ram, ram slots or psu (I changed all and nothing work), the exact problem is when you switch it on , it starts and after 1 seconds (no boot or display picture) it's off and then on cycle continuously until you power it off from psu also it's responding to the power switch for turning it off if you keep pressing it 3 or 4 seconds (power button pin has 3.3v) , also when you start it with eatx 12v socket connected this is happening (power cycle also all voltages are resetting...
      05-10-2023, 06:08 AM
    • Duranitron
      Asus x512dk rev 2.1 power on problem
      by Duranitron
      When I reflash again the bios of hoaca388 the unit powers on and the unit lives!!! Hooray!! All voltage in the coil 3.3v, 5v and 6.7v indicate charging are all present. including the cpu voltage , EEPROM and GPU voltage the unit is now alive, normal screen booting to windows and log in screen until I power it off. Then the unit never goes on even when pressing the power button in the keyboard.. Voltage reading 19v main , 3.3v VCC in IT8225E-128 and EEPROM VCC 0 volt and the charging voltage 0 volt.

      Try to trace the power switch button goin to the power switch IC PU8803 (APL3533AQBI-TRG)...
      11-26-2024, 10:22 PM
    • Thomas Smith
      Asus Tuf gaming fx506l no power, mosfet does not open
      by Thomas Smith
      Hello everyone, I have an ASUS FX506LI laptop that does not turn on, and I need help diagnosing the issue. Here is what I have checked so far:
      Initial Symptoms:
      • The laptop has no power at all (no LEDs, no fan spin).
      • No 3.3V or 5V present on the board.
      • The power button (NBSWON#) reacts but only changes from 0V to 0.5-0.11V.
      Power Rail Checks:
      1. Charger input (FETs PKCH2BB)
        • Drain: 20V, Source: 0V, Gate: 0V (FETs not switching).
      2. BQ24780S Charger IC:
        • VCC and ACDET are present.
        • ACN / ACP, ACDRV, BATDRV, LODRV, HIDRV, ACOK, SRN, SRP – all 0V.
        • Shunt resistor has 10Ω to ground.
        [*
      ...
      03-30-2025, 03:38 AM
    • Loading...
    • No more items.
    Working...