Hi everyone,in have the schematic,only need the Boardview,thanks in advance.
-
-
Re: la-4111p Boardview
Here the schematic if anyone need. -
Re: la-4111p Boardview
Comment
-
-
Re: la-4111p Boardview
Hi, does anyone know which program is needed to open the brd file? I've tried like ten and none does the trick.Comment
-
Re: la-4111p Boardview
Nevermind, I've found the Allegro viewer, thanks anywayComment
-
The Schematic and BoardView( *.cad ) of MSI Z390 A-PRO , the board model no is MS-7B98 Rev1.0-1.1 ....
-
Hi, I needed a schematic and boardview for this motherboard earlier and I found out it's not available to download on here as the links expired, so I found it myself, hope it helps someone.
Schematics and boardview attached below....06-25-2025, 05:02 AM -
Hello everybody,
I have the schematics already of this device but no boardview and it is being very difficult to locate the fault.
I have +3P3VAS but then nothing else, I suspect something related with 1V8 regulators, but without boardview it is very difficult to locate those components and or pads to test.
Does somebody has the boardview of this model? Or can point out where to test?
Thanks!05-12-2025, 03:29 AM -
If anyone has the boardview and can share I would greatly appreciate it! I have the repair guide, but I still need the boardview. My BMC cannot initialize, likely due to damage around the enable switch....
-
Hi guys, I have a problem with my laptop which is MSI GF66-11UE. 3-4 days ago I wanted to change thermal paste,unfortunately one of screw was become stripped and I forced a little bit that screw.Anyways when I finished the change of thermal paste and picked up the laptop at last I realized that I didn't put the edp connector inside but the problem is I put this while the battery was still connected the motherboard.That caused a few sparks.
Fortunately, the laptop booted up afterward. However, it was running using the CPU's integrated graphics, and it didn't detect the dedicated...
Comment