hi i need plf/plr/csf/csr uma 2.1 boardview or slj8e clear picture some risitors missing after replace chip .
-
-
Re: plf/plr/csf/csr uma board view please or
Image HD:
https://www.dropbox.com/s/bdigxvrmpo....2.1_.jpg?dl=0
https://www.dropbox.com/s/f9v55qxxoq...V.2.1.jpg?dl=0 -
Re: plf/plr/csf/csr uma board view please or
Thank you .Comment
-
Re: plf/plr/csf/csr uma board view please or
Thank youComment
-
Re: plf/plr/csf/csr uma board view please or
Boardview UMAComment
-
Re: plf/plr/csf/csr uma board view please or
thanks...Comment
-
Re: plf/plr/csf/csr uma board view please or
thanksComment
-
Re: plf/plr/csf/csr uma board view please or
thanks type5Comment
-
Re: plf/plr/csf/csr uma board view please or
Thanks for board viewComment
-
Hi There,
This TV was auto switching off after few seconds with some vertical lines on the screen, so got a new TCON board and replaced it.
After replacing the TCON board it was working fine and i set it up with everything, used for few hours, then had the bright idea to update the software on it. During the update process, TV switched off and now no audio or video. No relay switch sound.
More Details
TV Model - LG OLED77G1PUA
Got the same exact TCON board from TVPartsToday and replaced it. But didnt transfer the EPPROM data (didnt... -
I have a Panasonic TC-P54VT25 that will power on and prime the display but there is no image at all.
The panel is primed as there is a slight glow from the entire panel. This means the problem should be logic related. The service manual also confirms this and recommends replacing the A or the D board.
I have tried to get the TV to display the test sequence but I have been unable to and I don't even know if this TV has a test sequence or not. I tried following tom66's instructions in post #3 on this thread https://www.badcaps.net/forum/showthread.php?t=26790. There was... -
Hello!
I have been trying to solve this issue the past 12 months to no avail. I have been a lurker here during that time but finally decided to post my problem and see if anybody knows a solution.
Problem
My tv (OLED55CXPUA) has an issue where it displays horizonal lines of dotted artifacts.
(See Attachment 1)
Self Diagnosing
After a very long troubleshooting period I traced the issue to the T-Con board. If I gently flexed/bend the board I could make the display go from GOOD to BAD and vice versa. I have ruled out the connectors/wires... -
ONN 100012588
Issue: No Power, Then Rebooting After Main Board Change
Short answer: replace main board and power board
Technical answer: replace main board and Q306 & Q307 on power board.
Long answer:
TV wouldn't turn on. Power switch was fine which means the main board isn't processing the power on signal. Replaced main board. TV turns on now but randomly reboots. Bad main board? EEPROM? Tried to pull main board and got a shock touching the corner of the board. That's weird. C334 (450V 10uf) capacitor is still holding a high charge.... -
Hello
I have a Gigabyte X570 Aorus Pro rev1.0 that doesn't work. I know the motherboard is at fault because the CPU, RAM and power supply have all been tested with a known good motherboard (including after trying them in the faulty board to check it hadn't killed them).
Thanks to some people on this website and elsewhere on the internet, I have a schematic and boardview for the WiFi version of this board, a schematic for the Elite version of this board (same board but cut down on features) and repair guides for other AM4 boards, one of which is for an Asus Tuf Gaming...
Comment