PLEASE COULD SOME ONE HELP REPAIR THIS DUMP. it doent display but when i press the capslock and nmslock it give signal like a working machine
-
This specification for the ALIENWARE Steam Machine R2 can be useful for upgrading or repairing a desktop PC that is not working. As a community we are working through our specifications to add valuable data like the Steam Machine R2 boardview and Steam Machine R2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-12-2024, 03:28 PM
-
I have a post on psx-place for this but thought I'd try here as well in case anyone has experience or the schematics or any kind of help. Here's the original post from psx-place:
START
Hi, so I bought a YLOD Fat PS3 as I wanted a repair project and thought it would be a good way to get experience. I was able to solder to the RX, TX and Diag pads on the COK-002 motherboard and was able to get external access and retrieved the codes. I haven't powered it on beforehand so these should be the last ones. I did try to get internal access immediately after but kept getting scopen response... -
Hello,
i would appreciate, if someone could help me.
DELL: 3450 sff
Servicetag: (!) obviously FAKE - ABC2345
Mainboard: 0GK35Y - serial /ABC2345/CNFCW0023800L6/
Chipset: Intel W580 (Rocket Lake PCH-H)
BIOS: 1.34.1
ME: 15.0.50.2633
mor data can be found the HW-Info-data in the rar-file
I have this BIOS from a DELL Precision 3450 SmallFormFactor mainboard i bought refurbished.. from china.
The board itself works without any issues.
My goal was to clean the ME of this and fully... -
OK, this is a long shot. I got this sewing machine cheap because it's end of line, ex-display, and had no pedal. The genuine pedal costs £60, while Ebay knock-offs go for around £15. So I went for the knock-off, it doesn't work, and I'm not sure whether it's the pedal or the sewing machine that has the problem.
Now this is an electronic machine, unlike the old fashioned sort where the pedal was a big resistor in series with the power to the motor. Here, the pedal is just (I think) a variable resistor fed with a 5 volt supply, and limited to a current of 5 milliamps. Assuming that... -
Hi,
I need some advice about mainboard of Philips Coffee Machine PHILIPS EP5441 with 1.9.30.330.0
u2 is shorted. I can only read MX1 . cable goes to display panel....11-28-2025, 01:55 AM
Comment