cannot erase EON S64-100HIP with CH341

[ktmmotocross]

Hello.
I cannot erase EON S64-100HIP with CH341 on ACER ES1-521.

everytime i select erase, it show confirm imediatelly wich is bad. I have no problems with other chips. know anyoone some interchange like winbond ic?

[ktmmotocross]

Re: cannot erase EON S64-100HIP with CH341

i found that somebody want to add this to programmer

Name="EN25S64",ID="1C3817",Class="W25X10",Category="SERIAL_EPROM",MFG="Eon Silicon",Vcc="3.6V",CodeSize="8388608",Adapter="ADP-099+ADP-081, ADP-081A",Message="Put ADP-099 voltage jumpper on 1V8 position.";

does it mean i need to use 1.8V adapter or ?

[SMDFlea]

Re: cannot erase EON S64-100HIP with CH341

Use NeoProgrammer software, it supports the chip . https://www.badcaps.net/forum/showpo...04&postcount=7 .It is 1.8V

If you have a look at this chart on elnec you can work out what the part number means

https://www.elnec.com/en/device/cFeo...64+%5BSOP8%5D/

EN XXX XX X XX X X X

25S = 1.8V Serial Flash with 4kB uniform-sector FLASH
64 = 64Mbit (8192kx8)
100 = 100MHz
H = SOP8, 200mil
I = Industrial (-40°C to 85°C)
P = RoHS compliant

[ktmmotocross]

Re: cannot erase EON S64-100HIP with CH341

detect it, but still erasing took miliseconds and offcourse not erased

[ktmmotocross]

Re: cannot erase EON S64-100HIP with CH341

i took GD25LQ64C from NM-A311 which after been programmed fires on first try

[kalilinux25]

Re: cannot erase EON S64-100HIP with CH341

Use NeoProgrammer software, it supports the chip . https://www.badcaps.net/forum/showpo...04&postcount=7 .It is 1.8V

If you have a look at this chart on elnec you can work out what the part number means

https://www.elnec.com/en/device/cFeo...64+%5BSOP8%5D/

EN XXX XX X XX X X X

25S = 1.8V Serial Flash with 4kB uniform-sector FLASH
64 = 64Mbit (8192kx8)
100 = 100MHz
H = SOP8, 200mil
I = Industrial (-40°C to 85°C)
P = RoHS compliant

I tried to use this sir but It was taking forever to upload the new bios to the chip.. Do I need to attached a 1.8v adapter?

[SMDFlea]

Re: cannot erase EON S64-100HIP with CH341

I tried to use this sir but It was taking forever to upload the new bios to the chip.. Do I need to attached a 1.8v adapter?

The chip is 1.8V so what do you think ?