Hi all, I am working on a MacBook Air A1466 820-00165-A. It turns on fine (3.3-5v-1.8V all good), there is a fan spin & the initial startup too, the fans spins stops & then spins again, but no display all. Upon checkup I noticed that U3900 chip Heats up, I measrued a short in this area, C3931 & C3933 shorted. Actually the chip was shorted, this is why the caps were showing 0 ohms. I replaced the chip with a new one but now the chip gets very hot. Is there any reason why is this chip getting hot & no display at all. Appreciate a reply. Thanks
-
-
Re: MacBook Air A1466 820-00165-A U3900 Heats up
Hi I have the same A1466 in absolutely same condition. U3900 is not overheated and there is no shorts on caps near, but it has high temperature. Fan spins, all voltages are present, no image and backlight. Board has liquid damage on other side of cpu, I changed all components and checked all board for another damaged lines, but still no luck. Cpu temperature is very low, even when fan is off. I guess maybe cpu is dead -
Re: MacBook Air A1466 820-00165-A U3900 Heats up
found out that CPU_VCCSENSE_N is shorted to gndComment
-
I received a 2013 Macbook Air A1466 820-3437-B motherboard with serial number C02L6GQ9FSV8 that came in WITHOUT a bios chip. I got a new bios chip and reprogrammed it. Macbook now powers on but doesn't boot the SSD. I've flashed a ton of bios but still same problem. Windows installation works with this Macbook but never a mac installation. Unfortunately, since I didn't receive this macbook with a bios chip, I don't have the original bios. What can I do now?... -
Hello all,
Working on my wife's 13' Macbook air. It's been in a box since she upgraded but I figured it could be good practice.
Details:
Macbook 13' A1466
Board (820-3209-A)
Battery OEM 7.3v 50Wh 6700 mAh (020-7379-A)
Pictures below of Boardview and schematic...
I don't know how to test the voltage on a MacBook battery. I just assumed it had an enable pin but the best I could read was 300 something mV poking around the battery connector.
It's an older model and it is very likely that battery has become... -
Hi all,
i got a A1466 with serious water damage. I was able to clean the whole board and only found a fuse with a coroded trace. Cleaning and resoldering did the job and the macbook started normal but after some time the screen began "flashing" like turning on and off while the Macbook was still running. I checked the board again but was not able to find the problem until now.
Any ideas where to look?... -
Hi. Recently serviced a damaged A1466 Macbook Air. Thought to post the issues and resolution for each.
Macbook AIR Model A1466 Diagnostic 09-01-2021
Issue: Liquid damaged (beer spill) Macbook AIR will not power up.
Problems & Resolutions
1) Attached Apple magsafe power adapter. No green / no orange light. This confirms the absence of the PP3V42_G3H voltage rail. The PP3V42_G3H rail is the primary voltage rail necessary to communicate with the magsafe power adapter to report the green or orange light status to the end user....09-01-2021, 09:31 AM -
i have macbook a1466 board id 820-00165 with power fan spin green to orange light not booting no image or light i tried to fix its leak chip number U1930 but sad it has been damage due of corrosion here i attach the image of board. possible there is a jumper ways for it can't find parts for it to buy.
in first image there is 0v out for lcd
https://ibb.co/5XppmpkH
in 2nd image U1930 chip is damage is there any jumper solution or parts can be compatible for it
https://ibb.co/fdJkbJs8
Comment