hello everyone,
Casper N240 2 in 1 is a intel bay trail windows 10 tablet and notebook. one day after a long charge(my wife forget on the plug) i disconnect and see my charging light always red and not charging the batterty, in time tablet start to not boot and i replace the power ic (axp288).
Now it mostly won't have picture. if picture it says casper(bios logo) and red battery (nearly empty) than turns off. (but i charge the battery with a lipo charger i know it's full)
When on the boot logo if a press the bios button, i can enter the bios without a problem. save and quit bios, tablet restarts and tablet boot normally i can use my tablet until a close it.
And same loop again.
Now battery charging with tablet, i can read battery level on bios, check every solder on axp288 looks ok.
Where should i check?
Casper N240 2 in 1 is a intel bay trail windows 10 tablet and notebook. one day after a long charge(my wife forget on the plug) i disconnect and see my charging light always red and not charging the batterty, in time tablet start to not boot and i replace the power ic (axp288).
Now it mostly won't have picture. if picture it says casper(bios logo) and red battery (nearly empty) than turns off. (but i charge the battery with a lipo charger i know it's full)
When on the boot logo if a press the bios button, i can enter the bios without a problem. save and quit bios, tablet restarts and tablet boot normally i can use my tablet until a close it.
And same loop again.
Now battery charging with tablet, i can read battery level on bios, check every solder on axp288 looks ok.
Where should i check?
Attached Files
Comment