Lenovo G560 Compal LA-5752 charger stops with overcurrent

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Hexel
    Member
    • Jan 2019
    • 15
    • Ukraine

    #1

    Lenovo G560 Compal LA-5752 charger stops with overcurrent

    Hello!

    Need help in troubleshooting notebook G560. When with battery, charger ISL6521 starts charging, and after few seconds, when CHLIM input (current setpoint from EC) reaches 250mV, charger shuts down with audible click. After ~5ms EC turns off adapter input (ACOFF is asserted) and switch to battery input.
    When with only adapter, or battery, no problem.
    Tried different batteries, adapters. ISL, charger mosfets, bootstrap caps are replaced, no effect. Its nothing else issue, as process interrupts when ADP_I signal peaks and charger PWM pulses disappers. After that, EC puts EN input to ISL low.
    Maybe, any ideas?

Related Topics

Collapse

  • flat-earther
    ASUS X54H laptop thinks it's always charging even with charger unplugged
    by flat-earther
    The charging indicator light on my ASUS X54H laptop is always on even when the charger is disconnected.

    Windows also shows ''Plugged in'' when charger is not connected.

    This problem started year ago gradually, when unplugging the charger the charging light took several seconds to disappear, then minutes, and now almost always on even when unplugged for an entire day.
    Strangely, before sometimes immediately when plugging in the charger the charging light went away, and later came back with it connected.
    If I let battery run out and say it has 3% Windows will...
    06-24-2025, 09:32 AM
  • motormayhem
    Lenovo T460 Only Charges on One Charger
    by motormayhem
    Laptop Question
    Hello,
    I'm working on a Lenovo T460 that has been having trouble charging as of late. Its worked well since I've owned it for a few years. When I went to use it the other day it was dead and wouldn't turn on (was sitting on an Anker 65W GaN charger). After some fiddling with the charger I got it to turn on and start charging, but seemed like the charger was not working as it should (took a few plug and unplug cycles to get it to start charging).

    A day later it was dead again and wouldn't boot/charge no matter what I did. No lights or anything when...
    05-12-2023, 01:46 PM
  • flat-earther
    how to prevent a connected charger from draining battery when not charging?
    by flat-earther
    I have an RC radio handset(Taranis QX7) which doesn't have internal battery charger which means I had to remove the battery every time I needed to charge it.
    So to improve it, I added a 15W USB-C charger board(link) inside and soldered it to the same connector on the PCB where the battery plugs into, great, now I can simply charge it with a USB-C cable.

    but the problem I found is that after the radio sat for two weeks without being used the 2S 18650 battery that I'm using was at 4.2V!
    So the battery is backfeeding the charger and being drained.

    How can I prevent...
    Yesterday, 01:04 PM
  • Johndill
    Dell Inspiron 7567 LA-D993P odd charger issue
    by Johndill
    Hi, I have a Dell Inspiron 7567 LA-D993P that I've just got running.
    There was corrosion around PU1503 which shorted PC1518 & blew PL1504. (Reference pictures attached)
    I've replaced PC1518 & PL1504 & the laptop is now running however I now have another issue.

    Here are the tested scenarios:

    1. With the laptop running on battery, I plug in the 150W charger & the charger shuts off (no LED, protection mode) but the laptop remains running on battery.

    2. With the laptop off, plug in charger (LED says on) & the front charging...
    11-16-2022, 10:55 PM
  • Document Archive
    ISL6257HRZ ISL6257HRZ-T Laptop Battery Charger Datasheet
    by Document Archive
    ISL6257HRZ ISL6257HRZ-T Laptop Battery Charger Datasheet

    Highly Integrated Narrow VDC Battery Charger for Notebook Computers

    The ISL6257HRZ ISL6257HRZ-T is a highly integrated battery charger controller
    for Li-Ion/Li-Ion polymer batteries. ISL6257 is designed for
    Narrow VDC applications where the system power source is
    either the battery pack or the regulated output of the charger.
    This makes the max voltage to the system equal to the max
    battery voltage instead of the max adapter voltage. Operating
    at lower system voltage can improve...
    11-05-2024, 04:43 PM
  • Loading...
  • No more items.
Working...