Asus G750JZ R2.0 just need one resistor value

[Dr.xyz]

No picture on LCD panel, resistor between DDC power pin (pin 22 on display conn) and +3VS is open circuit. Probably caused by bad display cable, now replaced.

Value of resistor? It might be just 0 ohm, but just wanted to make sure.

[Duranitron]

Re: Asus G750JZ R2.0 just need one resistor value

No picture on LCD panel, resistor between DDC power pin (pin 22 on display conn) and +3VS is open circuit. Probably caused by bad display cable, now replaced.

Value of resistor? It might be just 0 ohm, but just wanted to make sure. Anyone have this schema?

try this schematics if its the same. ..https://www.badcaps.net/forum/attach...9&d=1507792334

[Dr.xyz]

Re: Asus G750JZ R2.0 just need one resistor value

No, it's not the same. DDC power comes straight from +3VS on that board, no resistor in between.

[SMDFlea]

Re: Asus G750JZ R2.0 just need one resistor value

No, it's not the same. DDC power comes straight from +3VS on that board, no resistor in between.

Rev 2.0 boardview - https://www.badcaps.net/forum/showthread.php?p=982113

[Dr.xyz]

Re: Asus G750JZ R2.0 just need one resistor value

Thank you, Sir!

It was indeed zero ohms, that's what I used already. After replacing, got picture with lots of static.

U6201 eDP to LVDS bridge chip was also damaged, took that from a donor board and after replacement picture was OK.

Previous shop also damaged display and HDD connectors, need to swap those too.