Dell LA-9984P

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • kokono
    Badcaps Veteran
    • Jun 2018
    • 203
    • Germany

    #1

    Dell LA-9984P

    i have this motherboard.it can start and after 4-5 second automatically turn off, i tested all voltage.
    I doubted to Graphic chip. i remove PL802 , and now working. in fact without dedicated graphic chip ,motherboard working .
    i tested PU800 (Digital chip for VGA line) ,Power good pin(No,2) have 3,3v after start .and also graphic chip in this time (4-5 second) is normal warm .
    any person have idea ? i think graphic chip is ok
    Attached Files
    Last edited by kokono; 04-19-2020, 11:41 AM.

Related Topics

Collapse

  • acedogblast
    Guide to transplant MEC1503 EC chip and EEPROM reprogamming for T14s gen 2 and X13 gen 2
    by acedogblast
    This is a guide that I am writing for helping others to replace their MEC1503 EC chip if it breaks (or to get around an inconvenient prompt to the BIOS). This forum has been extremely helpful to me so I would like to contribute to help others. I will tell you right now that this task is very difficult to do. You MUST have experience and tools to do precision micro-soldering, BGA reballing, trace repair, and general laptop repair skills.

    There are some specialty tools needed to do this task. The replacement MEC1503 chips can be acquired from Aliexpress. Do not buy the bare chips as...
    11-02-2024, 05:13 PM
  • ed1i
    Dell Inspion 7610 bios chip
    by ed1i
    Hello, I'm looking for bios chip on the motherboard on Dell Inspiron 7610. Server tag: CS4MDL3. I found on the back on the motherboard chip named: Winbond 25Q256JVEQ. Is it the right bios chip for this motherboard? I need to flash new bios on the chip, because it's stuck in infinity reboots. Is it possible this chip to be read AsProgrammer 25Q256JV option and ch341a programmer?...
    01-16-2025, 02:14 PM
  • donnietr
    Need help id'ing chip on a Dell g15 5515
    by donnietr
    Hello all,
    I have this dell g15 Ryzen Edition 5515. Board GDL56 LA-K453p. It had liquid damage when i bought it. Cleaned it up really well and then used thermal camera to see what got hot.
    Found the power pdw1 and pdw2 under the graphics card were getting hot. Pdw2 was hottest, i had a similiar chip on another board so i put it on this board.
    The other chip is now hot as well, which it was to begin with.
    Thats the problem as i dont know what to call it, like is it a mosfat? or what?
    I will attach a picture of both the boardlabel and of the area with the chips....
    Yesterday, 08:03 PM
  • ezenia
    Dell G3 3579 BIOS chip ID
    by ezenia
    Hello,

    I bought a Dell G3 3579 eBay. The fault was not mentioned and it did not come with charger. Before trying to power off battery, I did some basic checks on the coils (in resistance mode) to see if there was any short. None were reading short. Decided to power the board to see if anything happened. The keyboard backlight came on. About 5 seconds later, the fans begin spinning at max speed. The white LED comes on at this time, stays solid for a bit and goes off. Fans continue to spin at max. Display is black (no backlight). If I hold down power button, board goes off. I did give...
    06-16-2025, 08:07 PM
  • Bowline
    Dell E6400 PT434 type Battery Charging Stuck at 1%. Battery Pinouts?
    by Bowline
    My question pertains to understanding the control circuity inside a Dell PT434 type battery used in Dell E6400, E6410 and other Dell notebooks?

    Does anyone have a circuit diagram for the inside of a Dell PT434 battery and/or a description of how the control lines work to control this battery?

    My reason for asking is I have a battery which I cannot get to charge beyond 1% in a Dell E6410 or E6400.
    The LED bar graph charge indicator on the battery shows one LED lighted when the info button is pressed.
    I have tried multiple different Dell power adapters. My Dell...
    06-11-2025, 10:13 AM
  • Loading...
  • No more items.
Working...