Anyone know how to read the ITE 8587E using the setup like the picture ?
The chip was soldered directly onboard via adapter and PEB-1 using RT809F. But the software cannot find it and always say: Wait for ISP mode. I have checked over and over about soldering pins and sure that it is already correct and connected. I even tested pin by pin using the continuity meter so I am sure it is not about the ic connection problem
.
The chip was soldered directly onboard via adapter and PEB-1 using RT809F. But the software cannot find it and always say: Wait for ISP mode. I have checked over and over about soldering pins and sure that it is already correct and connected. I even tested pin by pin using the continuity meter so I am sure it is not about the ic connection problem
.
Comment