Need Help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • eng.umair.a
    Senior Member
    • Jun 2016
    • 79
    • Pakistan

    #1

    Need Help

    can i replace rtd2136r with rtd2136s? please help

Related Topics

Collapse

  • chth96
    Is it no harm to replace with capacitor without ripple current rating?
    by chth96
    When I tried to repair LG 29 inch CRT TV, I found that the ESR value of samyoung SMS capacitor(160v 2.2uf), which is very close to D1879 transistor, is 6 ohm.


    Judging from above ESR Meter Table,I think It is necessary to replace this sms capacitor.So I visited local electronics shop,and I purchased 160v 2.2uf rubycon YK capacitor.
    But when I browse through rubycon YK datasheet,I found that there is no ripple current rating for 160v 2.2uf specification. But On the contrary, I found 39 mA ripple current rating for 160v 2.2uf SMS capacitor.
    Rubycon YK DataSheet (b...
    04-19-2024, 05:19 AM
  • RetroComputingGrotto
    Opinions/Advice on Do/Should I replace ALL Electrolytic Capacitors on old equipment?
    by RetroComputingGrotto
    I've just been repairing some (very) old speakers with a loud hum that occurred as soon as you powered them on regardless if any actual audio is played through them. I work in a School so it's 99% likey that the Teachers have hardly ever turned the power off on them for well over 10+ years.



    As you can see the top large capacitor on the right has a bulge on the top so defincately needs replacing. As the one next to it is exactly the same capacity and voltage I planned to replace them both.


    What is your advice/opinion on whether or not on old(er)...
    04-03-2024, 08:30 AM
  • chth96
    Is it okay to replace 1/2 watt resistor with 1 watt resistor in AC/DC adapter?
    by chth96
    I have purchased an 100-240v AC/5v 2a DC adaptor from aliexpress,and a month ago It smelled burning when I plugin it powerstrip.
    Since then, This AC/DC adaptor have been out of order.
    But A few days ago,I replace 0.5 watt resistor with 1 watt resistor(1ohm) in this adapter.
    After replacing resistor,It succeed to recharge all of android phone.And When I measure voltage on the two pins of USB port,It shows 5.5v
    Is it okay to replace 1/2 watt resistor with 1 watt resistor in AC/DC adapter?
    And Is there any possibility that it will suddenly explode as well as to be out...
    12-03-2023, 04:40 AM
  • psyduck
    Conformal coating on Samsung U32D970 monitor PSU, do I need to replace after repair?
    by psyduck
    I have a Samsung U32D970 monitor from 2015 I pulled out of the bad hardware pile that turned on and then turned itself back off after a few minutes of use and refused to turn back on. The PSU has part number BN44-00786A, and I found a couple posts about one that had blown with damage to the MOSFETs and PWM controller - but nothing about intermittent failures. I started a new thread and said that I would refresh the solder joints on the board to see if it was just a bad connection and possibly replace the PWM and PFC ICs. I then asked what my next course of action would be after those steps. I...
    11-27-2023, 06:56 PM
  • pc_okay
    G703GXR Dead CPU? shorted CPU power mofset replace, missing DRAMRST#
    by pc_okay
    Hello friends,

    I replace a shorted mofset (PU8104), now laptop is starting but no display, stopping at DRAMRST#.
    Resistance to ground on PL8104 is around 1-2 ohm, quite low but voltage seems ok 0.995V

    Any help would be appreciated it's a nice laptop !

    Thanks. 😃
    04-02-2025, 04:48 AM
  • Loading...
  • No more items.
Working...