Announcement

Collapse
No announcement yet.

820-3209-a power on only without u7000

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    820-3209-a power on only without u7000

    hi
    my macbook is a water damaged one.
    I saw a short circuit in u7000 pin 14 so i removed it and the short was gone.
    Now without it the macbook turns on and it seems ok ( i don't know what u7000 is there for) i deceided to buy another u7000 from aliexpress, but when i place it with air gun, the mac stops turning on again (without any short)

    does someone have some advice to solve this problem?

    #2
    Re: 820-3209-a power on only without u7000

    pin14 is ac ok that goes to smc passing trouth a resistor. put u7000 and report all voltages on each pins. (watch out to short pins together)
    probably u have short on one of the mosfet that power 12.5 volt rail or some voltage from ac not ok.

    i suppose u dont have stable green light on ur charger...

    Comment


      #3
      Re: 820-3209-a power on only without u7000

      no green or orange lights
      here are all u7000 probes:
      pin 1 0v
      2 15v
      3 4v
      4 3.4v
      5 0
      6 0
      7 0
      8 0
      9 0
      10 3.4
      11 3.4
      12 3.4
      13 0
      14 3.4
      15 0
      16 0
      17 no probe
      18 no probe
      19 5v
      20 5v
      21 0v
      22 gnd
      23 8v
      24 8v
      25 8v
      26 13v
      27 15v
      28 15v

      Comment


        #4
        Re: 820-3209-a power on only without u7000

        voltage on fuse near battery? without battery.

        is it a air model ?

        Comment


          #5
          Re: 820-3209-a power on only without u7000

          8v with battery and same without it

          yes it is an air model

          Comment


            #6
            Re: 820-3209-a power on only without u7000

            check one wire circuit. u7000 is ok.

            Comment


              #7
              Re: 820-3209-a power on only without u7000

              where is one wire circuit?

              Comment


                #8
                Re: 820-3209-a power on only without u7000

                i dont have schematic for this...

                Comment


                  #9
                  Re: 820-3209-a power on only without u7000

                  you mean pp3v42_g3h right?
                  if yes it is pin 12 of u7000 and the voltage is present yet 3.4 volts...

                  Comment


                    #10
                    Re: 820-3209-a power on only without u7000

                    i mean the magsafe dc in pins voltage on mainboard. 1 is gnd, 2 are 16 volt and one should be around 3 volt. i think u dont have that 3 volt and follow schematic to see why u dont have.

                    have u already tried a smc reset ofcourse ?

                    Comment


                      #11
                      Re: 820-3209-a power on only without u7000

                      Here are the schematics and boardview+viewer.
                      I would start at page 52

                      schematics and boardview https://www.badcaps.net/forum/troubl...-and-boardview

                      Comment


                        #12
                        Re: 820-3209-a power on only without u7000

                        tnx for sharing schematics.

                        for macbook. pin 13 of u7000. check why u dont have voltage here.

                        Comment


                          #13
                          Re: 820-3209-a power on only without u7000

                          check page 42 u5010 pin 5 for smc_reset,and do smc to see if that helps

                          Comment


                            #14
                            Re: 820-3209-a power on only without u7000

                            pin 5 of u5010 gives 0 volts
                            how i do a smc reset?

                            Comment


                              #15
                              Re: 820-3209-a power on only without u7000

                              remove battery and power supply , press and hold power botton 10 seconds.

                              edit: check r5000 if 100k.

                              Comment


                                #16
                                Re: 820-3209-a power on only without u7000

                                r5000 is 80k with my multimeter...

                                Comment


                                  #17
                                  Re: 820-3209-a power on only without u7000

                                  voltage on both side of r5000 ?

                                  Comment


                                    #18
                                    Re: 820-3209-a power on only without u7000

                                    3.4 on pin 1 and 0 on pin 2

                                    Comment


                                      #19
                                      Re: 820-3209-a power on only without u7000

                                      https://www.youtube.com/watch?v=04YpQCXgLyU

                                      same problem as u do have. try replace u5010 or reflow smc.

                                      Comment


                                        #20
                                        Re: 820-3209-a power on only without u7000

                                        i have replaced r5000
                                        now it turns on by itself with fan at maximum speed but screen doesn't turn on

                                        i think i'm near target, what can i do now?
                                        Last edited by opethfan; 02-17-2017, 02:18 AM.

                                        Comment

                                        Working...
                                        X