No 5V found in this Circuit, Please help me.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • nazrul145
    Badcaps Veteran
    • Jan 2014
    • 335
    • BD

    #1

    No 5V found in this Circuit, Please help me.

    Hi there, I have problem with this motherboard. This laptop have no power. I have check only 3.3v is present in P10 but 5V is no there in PL9. I check Pl9 to ground but no short found.
    So I have replaced uP6182 with TPS51125. But 3v present and no 5V.
    I also flash bios. But bad luck.
    So i specially need your help. Please Suggest me how can i find the problem.
    Schematic attached below.
    I wait for your help.
    Thanks advance
    Attached Files
  • Compute
    Master
    • Oct 2014
    • 97
    • Russia

    #2
    Re: No 5V found in this Circuit, Please help me.

    Что на 1 и 6 выводе pu11?

    Comment

    • Compute
      Master
      • Oct 2014
      • 97
      • Russia

      #3
      Re: No 5V found in this Circuit, Please help me.

      What is the voltage at the output 1 and 6 pu11?

      Comment

      • nazrul145
        Badcaps Veteran
        • Jan 2014
        • 335
        • BD

        #4
        Re: No 5V found in this Circuit, Please help me.

        Thank for response, Pu11 PIN 1=0V AND PIN6= 0.9V

        Comment

        • Compute
          Master
          • Oct 2014
          • 97
          • Russia

          #5
          Re: No 5V found in this Circuit, Please help me.

          Проверь номиналы pr82,pr86 - должны быть 0 Ом, и pr197,pr198 - должны быть 100 кОм

          Comment

          • Compute
            Master
            • Oct 2014
            • 97
            • Russia

            #6
            Re: No 5V found in this Circuit, Please help me.

            Originally posted by nazrul145
            pin6= 0.9v
            Должно тоже 0 быть...

            Comment

            • Compute
              Master
              • Oct 2014
              • 97
              • Russia

              #7
              Re: No 5V found in this Circuit, Please help me.

              Check face values pr82, pr86 - should be 0 ohms, and pr197, pr198 - should be 100 kOhm

              Comment

              • nazrul145
                Badcaps Veteran
                • Jan 2014
                • 335
                • BD

                #8
                Re: No 5V found in this Circuit, Please help me.

                PR82 =0 ohm and pr86 blank pr197= 98.5 ohm pr198=101.2 ohm

                Comment

                • Compute
                  Master
                  • Oct 2014
                  • 97
                  • Russia

                  #9
                  Re: No 5V found in this Circuit, Please help me.

                  Originally posted by nazrul145
                  pr86 blank
                  Sorry, do not understand ...
                  On the PR86 does not show resistance

                  Comment

                  • nazrul145
                    Badcaps Veteran
                    • Jan 2014
                    • 335
                    • BD

                    #10
                    Re: No 5V found in this Circuit, Please help me.

                    There is no resistor found , it is gap.

                    Comment

                    • Compute
                      Master
                      • Oct 2014
                      • 97
                      • Russia

                      #11
                      Re: No 5V found in this Circuit, Please help me.

                      Strangely, the scheme there should be a resistor, not to be confused with PJ11?
                      Take a picture of the place where there are PR86 ...

                      Comment

                      • Compute
                        Master
                        • Oct 2014
                        • 97
                        • Russia

                        #12
                        Re: No 5V found in this Circuit, Please help me.

                        Originally posted by nazrul145
                        pr197= 98.5 ohm pr198=101.2 ohm
                        Again it is written that in the scheme of these resistors to 100k, and you are on a 100 ohm
                        Scheme from that board?

                        Comment

                        • Compute
                          Master
                          • Oct 2014
                          • 97
                          • Russia

                          #13
                          Re: No 5V found in this Circuit, Please help me.

                          Need voltage PQ14
                          Drain
                          Source
                          Gate

                          Comment

                          • nazrul145
                            Badcaps Veteran
                            • Jan 2014
                            • 335
                            • BD

                            #14
                            Re: No 5V found in this Circuit, Please help me.

                            Sorrry Pr198 and 197 are kohm.
                            Attached Files

                            Comment

                            • nazrul145
                              Badcaps Veteran
                              • Jan 2014
                              • 335
                              • BD

                              #15
                              Re: No 5V found in this Circuit, Please help me.

                              Pq14?

                              Comment

                              • Compute
                                Master
                                • Oct 2014
                                • 97
                                • Russia

                                #16
                                Re: No 5V found in this Circuit, Please help me.

                                What's this ?
                                Originally posted by Compute
                                Need voltage PQ14
                                Drain
                                Source
                                Gate

                                Comment

                                • Compute
                                  Master
                                  • Oct 2014
                                  • 97
                                  • Russia

                                  #17
                                  Re: No 5V found in this Circuit, Please help me.

                                  Originally posted by nazrul145
                                  Pq14?
                                  Yes

                                  Comment

                                  • nazrul145
                                    Badcaps Veteran
                                    • Jan 2014
                                    • 335
                                    • BD

                                    #18
                                    Re: No 5V found in this Circuit, Please help me.

                                    There is no PQ14.

                                    Comment

                                    • nazrul145
                                      Badcaps Veteran
                                      • Jan 2014
                                      • 335
                                      • BD

                                      #19
                                      Re: No 5V found in this Circuit, Please help me.

                                      Sorry PQ14 gate=4.57v drain 0v and source connected with ground.

                                      Comment

                                      • Compute
                                        Master
                                        • Oct 2014
                                        • 97
                                        • Russia

                                        #20
                                        Re: No 5V found in this Circuit, Please help me.

                                        Originally posted by nazrul145
                                        Sorry PQ14 gate=4.57v drain 0v and source connected with ground.
                                        Should be 0V

                                        Comment

                                        Related Topics

                                        Collapse

                                        • Alimash
                                          op amp circuit function?
                                          by Alimash
                                          Hi,
                                          I am repairing a ups which doesn't turn on ,it has the following ICs:
                                          SG3525 used to drive inverter mosfets.
                                          couple of uc3483, one for the power supply and another to drive a big mosfet at the output stage(i think the technique is called boost)
                                          A LM358 and TL074 for control mechanism and of course the uController.

                                          The SG3525 is shutting down every time the ups is turned on.
                                          I want your help to know the function of LM358 and TL074 in the system.
                                          I reverse engineered the LM358 circuit and i think that one of the block(A) is used for battery level...
                                          07-31-2025, 07:45 AM
                                        • javieromex
                                          Dell G15 5511 LA-K452P won't turn on
                                          by javieromex
                                          Hello, any help will be apprecited!
                                          • Model: Dell G15 5511
                                          • MB: LA-K452P
                                          • Issue: Won't turn on at all, no leds, no keyboard light, no fan spin, nothing happens when pressing power button. NOTHING.
                                          • Customer reported it was turned off and left plugged in during the night and thats it...
                                          • No signs of liquid damage or burned components.
                                          Link to Schematics -> https://www.badcaps.net/forum/troubl...la-k452p-gdp50

                                          I have checked so far:

                                          ...
                                          04-17-2025, 12:44 PM
                                        • master3112
                                          ASUS ROG Strix- G513IH-HN008, G513-6050A3249301- MB-A04 (A4) damaged Embedded Controller
                                          by master3112
                                          I have an ASUS ROG Strix- G513IH-HN008, motherboard G513-6050A3249301- MB-A04 (A4)

                                          When I received the device, the device has no function. After an investigation, I found that the PWM CONTROLLER RT6575B (U6100) is getting warm and there is a short circuit at the 3V3 output. This normally supplies 3V3 for the embedded controller IT5571E-128 (U301). When measuring and analyzing with a thermal imaging camera, I found that some components are damaged: SLG4E42553VTR (U8500), IT5571E-128 (U301), LAN RTL8111H (U450), LOGIC 74LVC1G08GW (U1900), RT6575B (U6100) All these components are on...
                                          10-29-2024, 09:32 PM
                                        • Grouickman
                                          Hofmann geodyna 6300 Wheel balancer
                                          by Grouickman
                                          Hi there,

                                          First, I'm not sure it's the right section to post for this type of device, but could not think of something better.

                                          Ok, so my son (a mechanic) bought a faulty Hofmann Geodyna 6300 wheel balancer (which appears to be mostly a re-branded Snap-on wheel balancer).

                                          I'm looking for any resources (doc, manuals, schematics) that would be available for this device or anyone that would have any knowledge on this particular device (or its Snap-On equivalent).

                                          I'm trying to diagnose the fault(s ?), but I can't find any schematic (appart from the...
                                          03-31-2025, 05:29 AM
                                        • Astonished
                                          Fixing the Charge Circuit of the Batteries of the DC Motor
                                          by Astonished
                                          Hi friends of electronics

                                          What you see in the video and pictures attached is the circuit for charging the batteries of a DC motor.

                                          The problem is that this circuit cannot charge the batteries (3 1800mAH NiMH batteries) any more. When the circuit was OK, its green LEDs lit up one at a time to show that the batteries have charged more. But now that the circuit is flawed, LEDs light up as you see in the video and at the same time successive beeps are heard.

                                          Please help me fix this circuit.

                                          (the datasheet of the IC: https://pdf.datasheet.live/28...
                                          01-28-2025, 06:24 AM
                                        • Loading...
                                        • No more items.
                                        Working...