New Members
Please consider donating to this site if it has helped you. We rely on these donations.
Please also introduce yourself here Introduce yourself here.
And finally, Read the Forum rules here.
HP 15s-fq0008no does nothing and some items are very hot
Hi everyone,
I'm looking to buy a replacement **casing / housing** (either top cover, bottom base, or full chassis) for my laptop:
📌 Model: Avita Liber 14"
🔢 Model Number: NS14A2MY036P
My original casing is cracked and I’m hoping to replace it. I’m open to:
- New or used parts
- Full chassis or just top/bottom shell
- Compatible parts from other Avita V14 / NS14A2 / NS14A8 models
If anyone has a non-working unit with intact body parts or knows where to get one, please let me know....
So I got the bright idea to remove the LED light module from the fixture and put it on top of another enclosure and keep using the zapper
The removal of light module was a successful and now I just have to cut a hole in the enclosure and put a power cord that has an on and off switch on it
You are lucky to get about two years of service out of one before the LED module starts flicking and just stops working because it is mounted on an aluminum plate and these are hard to solder on it and it is not worth messing around with them and especially this one because it has line...
please help friends thinkpad T470 board CT470 series NM-A931 error post "bottom cover tamper detection error"
I've already
flashed the bios clean me and updated from the Lenovo site, then removed the switch and immediately jumped the S3 from pins 1 to 4, 2 to 3 but the problem remained the same, thank you
As stated by the person I collected the TV from, it just stopped working overnight. However, I still gave it a go to try and repair it.
There is a thread on the same TV but with slightly different issues where they had to tape connection points on the ribbon cable, so I want to see if this is repairable by any chance.
After bringing it home and plugging it in, the TV turned on with its backlight working but had no picture. After removing the back cover, the first thing I tried is to unplug one of the ribbon cables and the situation is as follows.
as above shows coloured lines then slowly goes down and repairs the picture on start up if been on for a while then turned off its fine anyone had this...