hp 15 eg1015nl programming ITE IT5570e problem
Hi guys, I hope this is the right section. Sorry for my English. I fixed an HP with an IT5570e and a shorted charger. I fixed everything. Now I need to program the IT5570e correctly, but I have a few problems. The motherboard is a DA0G7HMB8H0 REV H. Can anyone help me out and tell me how I can connect my RT809H to the board so I can write my IC? Thanks to anyone who can help.
-
-
Schematics here for similar board DA0G7HMB8G0 https://www.badcaps.net/forum/troubl...09#post3628309
Maybe minor differences, but the keyboard and battery connectors are the same
I found this video for programming ITE EC with RT809H via the SMBUS interface through battery connector https://www.youtube.com/watch?v=E7pCX7k4Jwk , using the schematics you can figure out the pinout for SMC and SMD; or if you wish to use the keyboard interface, all the KSO(0-15) signals are labeled MY(0-15), and KSI(0-7) are labeled MX(0-7) -
Comment
-
I have an LG Plasma TV 60PM6700 for the past ~12 years.
In the last ~3-4 months I have been having some issues.- Problem: It started with random picture disappearing (sound still worked).
Frequency: Happened about once a week.
Solution: Had to turn off TV wait a few seconds before turning it on again. - Problem: Then it got worse and the TV started to shut down and when turning on the no picture just sound.
Frequency: Happened about once a week.
Solution: Had to turn off TV wait about 10-20 seconds and turn it on again to solve. - Problem: TV shuts down
- Problem: It started with random picture disappearing (sound still worked).
-
Hello. I need some info. I have very good programer CHIPProg-481, fast and good programmer, but now I want read and modifi laptop bios dump without desoldering it. So want buy new programmer like RT809H for ISP programming for laptop bios. It is good for isp programing? or you recoment other? -
i have a problem with thinkpad X1 carbon gen 2 "LMQ-1MB 12298-2 48.4LY26.021"
The laptop was turned off because the MOSFET was not transmitting voltage. After checking it turned out that the gate pin on the MOSFET was the problem, because it was producing an inappropriate voltage. and it was discovered that the problem was with the Think engine, so I decided to reprint each pin, and finally the mosfet could work properly. However, there is another problem, even though the voltage has been supplied to the laptop, it still won't turn on, there isn't even an LED indicator. After double... -
Hello, Please I need a general knowledge in ISP programming for the RT809h. For instance an 8 pin bios chip, which one is the DO, CLK, CMD VCCQ of which I know pin 4 GND and PIN 8 is the VCC.
1.
2.
3.
4. GND
5.
6.
7.
8. VCC
Please help me. Thank you
-
Hai Guys, I need help here
I wanna to reprogram EC Ene KB9026Q C,
if you guy see my picture no 1, that (pin 9 : KSI4) is not connected,
already test the pin from Keyboard connector to SVOD3, its not problem.
but somehow, its said pin false.
Try to ignore it, but still cannot read id (picture 2)
Its that mean my EC ene is bad?...
Comment