Toshiba R940 with water damage

[ianbak]

Hi,

I have a Toshiba R940 which doesn't power on (fully) due to liquid damage. The mother boards is FAM2SY2 A2356A.

Most of the corrosion has cleaned up well, although I can see a few joints that need touching up. More troubling is the fact that one of the components appears to have been eaten off the board. You can see it if you zoom into the attached photograph, and it is clearly missing in the close up view.

I can't find a schematic for this motherboard, and wondered if anyone had any ideas about identifying the missing component?

[cappernicus]

It is a 100ohm resistor. I have the r945, but they appear to be the same board. As a sanity check, the one below it is a 1k.

I don't know if you still need it or not, but I hope this helps.

[ianbak]

Hi Cappernicus,

Thanks so much for that! I didn't get a notification so I've only just seen your reply. I'll replace it and see if things improve!