A2485 no image and no backlight after chip transplant on new screen.

[1centchips]

Removed the two chips from the broken lcd at 350C and 40 air by properly protecting rest of the area with copper and kapton tape.
Did the same with the new replacement panel.
Reballed the pulled chips and installed on the new lcd panel at 250C and 40 air
I have done few ones before without issue.

The new panel was working before I transplanted the chips. Now the computer turns on and boots but no image/ backlight. (
Anybody face this issue before?

[spwoof]

I had the same problem on a device. Unfortunately it was not possible to return the original LCD as it was broken.
Did you return with the 2 original chips that were removed from the new LCD? Have you tested? Did the new LCD with the original chips have an image again? Thanks