Re: Del N5010 not powering up. CK=DC chip burning hot.
i am looking for motherboard circuit diagram for intel i series wre can i get
i am looking for motherboard circuit diagram for intel i series wre can i get
-
-
Re: Del N5010 not powering up. CK=DC chip burning hot.
here is the schematic: http://www.mediafire.com/view/jx87d5...9-1_4HH01).pdf
pass: vvacl
Check:
Pin 3 = 2V
Pin 8 = 3v3
Pin 17 = 5vComment
-
Re: Del N5010 not powering up. CK=DC chip burning hot.
sorry for post in this thread taht im not owner. i wont to start a new thread cause my account is recently createe. I got a similar problem my m5010 dell inspiron laptop had a burned chip. named
line 1 : CK=CA
line 2 : m.18
Line 3: .
Plz can plz u identify these valorsComment
-
Re: Del N5010 not powering up. CK=DC chip burning hot.
its nuvoton chipComment
-
Sorry for reopen comment. I had the same issue. Remove coil but it still hot burning. Dell 5010 rt8205b
When i take out rt8205b no anything. But resold it hot. Pin 13 en is 18volComment
-
Remove all power. Check the resistance to ground on the output rail of rt8205b. The enable at 1v8 is enabling the voltage rail. If this regulator is hot then the downstream rail is too high for this component.Comment
-
Thank you all friends. Finally, i found a small capacitor in RTC power circuit short. The resistor to ground of pin 8 has 107k. Then when remove its 0L. Everything is okComment
-
This is a guide that I am writing for helping others to replace their MEC1503 EC chip if it breaks (or to get around an inconvenient prompt to the BIOS). This forum has been extremely helpful to me so I would like to contribute to help others. I will tell you right now that this task is very difficult to do. You MUST have experience and tools to do precision micro-soldering, BGA reballing, trace repair, and general laptop repair skills.
There are some specialty tools needed to do this task. The replacement MEC1503 chips can be acquired from Aliexpress. Do not buy the bare chips as... -
Common SPI bios chip programming Questions and Answers
----------------------------------------------------------
Q: I have a bios request,i can`t post my backup as i can`t read from the chip.
A: If you can`t read from it how do you expect to write to it ?.
Q: Why is my bios chip unreadable ?.
A: The programmer is faulty or has a worn or broken zif socket.
The USB cable is frayed,connector pins worn or some other physical damage.
Not enough amperage or voltage to power the programmer properly.
Bad...09-02-2021, 04:40 PM -
Long story short:
- dad converted Asus Chromebox CN62 into Windows compatible, with mrchromebox BIOS, years and years ago
- gave the computer to his son a couple years later
- son now decided to revert it to Chrome OS, to sell it as original (re-writing BIOS with the backup one created by his dad)
- too lazy to remove the board from the case, thought a voltage regulator was the BIOS chip (you know... it has 8 legs)
(seems like the story was not that short)
He used alligator clips to read the chip. No luck reading it. Removed chip and placed on a SOC-8... -
Hello, anyone here have updated ezp2023+ chip database in .dat file format.
I need to add w25q256jveq chip but I do not know what data should I type.
I'm using the ezp chip dabase editor posted from here https://www.badcaps.net/forum/troubl...ro-programmers
The currenty unit model that I am trying to detect is HP elitebook 640 g9 which is currently locked on admin bios....11-25-2024, 12:53 AM -
Thanks for any help. The board version is DAZAARMB6E0 REV: E. The bios chip is winbond 25Q64JVSIQ1736. W25Q64JV is not available in AsProgrammer -- only BV CV FV or FW_1.8c. The chip won't interface with asProgrammer and a CH341A. When I have this chip on the board, the laptop will not post but when I plug it in to power, the blue LED lights up, also the orange when the battery is connected. When I push the power on button, keyboard backlight turns on and the fan starts briefely then turns off. But I can't do anything to program this bios chip so I bought another one.
The BIOS...
Comment