southbridge heat problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • masud
    Badcaps Veteran
    • Jul 2011
    • 317
    • Bangladesh

    #1

    southbridge heat problem

    my acer laptop runs well, no problem but the southbridge gets too hot. what can i do.
    please help.

    masud.
  • are-red
    Member
    • Feb 2013
    • 24
    • malaysia

    #2
    Re: southbridge heat problem

    Hmm...u can try reball or also reflow.

    Comment

    • ben7
      Capaholic
      • Jan 2011
      • 4059
      • USA

      #3
      Re: southbridge heat problem

      Does it have a heatsink on it? What mfg/part-number is it? Is it being fed the right voltage? Clock frequency OK?
      Muh-soggy-knee

      Comment

      Related Topics

      Collapse

      • theone111
        Problem with LG Plasma 60PM6700 - Random power downs
        by theone111
        I have an LG Plasma TV 60PM6700 for the past ~12 years.

        In the last ~3-4 months I have been having some issues.
        1. Problem: It started with random picture disappearing (sound still worked).
          Frequency: Happened about once a week.
          Solution: Had to turn off TV wait a few seconds before turning it on again.
        2. Problem: Then it got worse and the TV started to shut down and when turning on the no picture just sound.
          Frequency: Happened about once a week.
          Solution: Had to turn off TV wait about 10-20 seconds and turn it on again to solve.
        3. Problem: TV shuts down
        ...
        07-22-2024, 10:36 AM
      • Zeonalbasta
        Thinkpad X1 Carbon "LMQ-1MB 12298-2 48.4LY26.021" VCC3M problem
        by Zeonalbasta
        i have a problem with thinkpad X1 carbon gen 2 "LMQ-1MB 12298-2 48.4LY26.021"
        The laptop was turned off because the MOSFET was not transmitting voltage. After checking it turned out that the gate pin on the MOSFET was the problem, because it was producing an inappropriate voltage. and it was discovered that the problem was with the Think engine, so I decided to reprint each pin, and finally the mosfet could work properly. However, there is another problem, even though the voltage has been supplied to the laptop, it still won't turn on, there isn't even an LED indicator. After double...
        09-13-2024, 01:17 PM
      • perzyk23
        Lenovo T580 - LCD Panel problem - error 0288
        by perzyk23
        Good morning,
        I have a problem with Lenovo T580, which after error code 0288 suggests a problem with the display. I checked the display and it works on another laptop. I replaced the display cable with a new one. I programmed another BIOS (downloaded from this forum) and I still have the problem of a dead display - there is an image via HDMI, and the system does not detect the built-in LCD at all. The problem appears to be hardware. What can I check to confirm or disprove this? I found many threads on the Internet related to this problem 0288, but without specific solutions. Please advise....
        10-25-2024, 12:42 AM
      • SDNarcia
        Dell 15R-5521 keyboard problem (KBC?)
        by SDNarcia
        Hello, I have a Dell 15R-5521, with the problem that the Ctrl, Alt, Shitf and Num Lock keys do not work, I tested the keyboard with a keyboard tester and it is functional, I also got another new keyboard and the computer has the same problem with the same keys. Check continuity between the ZIF connector from the keyboard to the KBC and all pins are correct. I cleaned the ZIF connector and the KBC and I still have the same problem. I reinstalled windows just in case, and it didn't work. I updated the BIOS to the latest version A16 and there were no changes.

        As additional information,...
        07-20-2024, 10:47 PM
      • s_specialist
        Lenovo E15 Gen 2 GE4B0 GE5B0 NM-D011 Rev 1.0 sometimes not opening problem
        by s_specialist
        Recently, I have started to encounter a problem with Lenovo E15 Gen 2 models not opening. When you try to open the device, it gives a warning sound and does not display an image, when you apply light pressure on the keyboard, the image appears and works for a while, when you turn it off and on, the same thing happens again. Bios was tried, RAM slots were cleaned and soldered to the legs, the problem still persists. There seems to be a problem with the onboard processors, but since Lenovos glue the processor firmly from the sides, the paths are very damaged when removing it. Has anyone encountered...
        07-07-2025, 11:47 AM
      • Loading...
      • No more items.
      Working...