e5-471 shorted +3V_RTC
Collapse
X
-
Tags: None
-
Re: e5-471 no power
Very Very likely its a shorted PCH -
Comment
-
Re: e5-471 shorted +3V_RTC
Thats for Intel to answer but this is a very common fault specially on SOC motherboards. RTC shorting in PCH section is affecting newer generations as well-already faced 5-6 cases of RTC section of PCH shorted on 11/12th gen intel platforms.Comment
-
Re: e5-471 shorted +3V_RTC
sir if in the case, the PCH is heating by injecting 1v, is it Sure that the root cause is the PCH itself and not the components (e.g cap, resister etc.) on its path?Comment
-
Re: e5-471 shorted +3V_RTC
.----------------------------------------------------------------------------------------------------------------------------------------------------------
All donations to Badcaps are welcome.
Become a Badcaps supporter
>>>>> click on this link to donate <<<<<
Thanks to all supporters.
----------------------------------------------------------------------------------------------------------------------------------------------------------Doctrina est fructus dulcis, radicis amarae..Comment
Related Topics
Collapse
-
by YanlebHi every one. I just want to share the successful repair of my shorted Panasonic TNPA4782AB SC board.
I don't usually do it but so many parts were shorted that I decided to buy the ShopJimmy repair kit instead of sourcing each components individually. Here is the list of components the kit contained, with a remark indicating if I needed that part or not :
D608, good
D618 RF101L4S, good (See warning 1 below)
D619 RF101L4S, good (See warning 1 below)
D865 RF101L4S, shorted (See warning 1 below)
IC464 Inverter HA MC74HC1G14, shorted...03-09-2020, 12:00 AM -
by modtoolHi to all,
the owner of this machine gave it to me after having opened it to take off the dust from the inside, telling me that after that it didn't start anymore.
I found that one of the DrMOS (AOZ5016QI) on the CPUCORE was shorted between VIN and VSWH, and that one of the two n-mos connected to the power jack was shorted aswell.
I unsoldered the two shorted components and verified that there were no other short circuits, then decided to power the mainboard, firstly with the lab power supply, then with its original HP 200w charger, but the behaviour is the same, the board starts... -
by BalkanBoyHi,
today I got Razer Blade 14, Ryzen 9 6900HX and RTX 3070Ti.
Laptop was completely dead. I found shorted CPU VRM mosfet, shorted 19V mosfet and blown battery fuse.
I replaced it all, but still on CPU coil where mosfet was shorted I got very low resistance, near 0 ohms. On other CPU coils I got around 3 ohms.
Laptop now raises voltage on whole board, but still nothing comes on the screen. CPU gets 0.7V on all coils except the shorted one. CPU gets only slightly hot, below 40 C.
I removed coil and injected 0.7V, it draw around...09-27-2024, 12:44 PM -
by guizmo1967Hello,
This is my problem:
Laptop: Dell Latitude 5501
Motherboard: EDC51 LA-H181P
I have two power rails shorted to ground, +1.0V_PRIM and +3.3V_ALW_PCH. I removed solder on PJP302, +1.05VALWP (pad1) not shorted but +1.0V_PRIM (pad2) shorted.
I also cleaned PJP38, pad1 not shorted, pad2 (+3.3V_ALW_PCH) shorted to ground.
I measure the resistance of all the coils on the motherboard and they all were not shorted to ground except coil PL301 before I removed the solder on PJP302.
I injected +1.05V - 2A... -
by FriedFredASUS ROG STRIX G713IC-HX041W, Mainboard G513-MP-GBM, battery shorted out
6050A3249305-MB-A01
2021-11-05
Hello, everyone!
I have some trouble with the G513-MP-GBM board, it's from an ASUS ROG STRIX G713IC-HX041W.
The total current consumption was about 200mA. The 0.8 Volt rail at the CPU was correct working.
But the power button has not been pressed...
I found some spurious solder between the pads 6 (VRA_SVT) and 7 (APU_PWR_EN) of the PWM-controller, "U66000".
Which can explain why this power rail has been starting without... - Loading...
- No more items.
Comment