SSD doesn't work after being removed from RAID0

[BalkanBoy]

Hi, I got issue with Corsair MP600 500GB drives.
I was using them in MSI GT83VR in RAID0 mode few months back, at some point I didn't needed them anymore so I removed them and stashed away.

Now I took one of those trying to install it in another machine, just single disk. BIOS recognizes it normally but when I try to install windows, installer reports drive with capacity of 927GB instead of 500 or less.

I couldn't do anything with diskpart and clean function or any other function I tried. I tried changing disk modes in BIOS and other basic stuff but didn't work.

Does anybody got idea how to bring it back to life again?

[pfrcom]

Re: SSD doesn't work after being removed from RAID0

https://wiki.archlinux.org/title/Sol..._cell_clearing

Tip:

I boot MX Linux 19.4 (version before current 21.2) from a USB key

I found 21.2 doesn't wake cleanly from Suspend, if necessary to reset SSD security Frozen by doing so


Edit:

I just discovered Corsair MP600 is an NVME drive

Above won't work on NVME drives

I have used Parted Magic 220904 to clear an NVME drive

Which I got on 1-Nov-22 from https://en.taiwebs.com/windows/downl...agic-2298.html