Asus Maximus VI Gene - error code 00.
Tray with another cpu,ram,psu with 8 pin,stock cooler.
Any ideea?
Thanks in advance.
Tray with another cpu,ram,psu with 8 pin,stock cooler.
Any ideea?
Thanks in advance.
-
-
Re: Asus Maximus VI Gene - error code 00
Disconnect the Reset switch, if it's connected.
Does the fan spin when you press the Power On Button, and shut down if you hold the Power Button in?
Have you checked the voltages on the motherboard - 12V, 5V 3.3V, Vcore, VRam etc?Last edited by dicky96; 09-11-2019, 08:55 AM.Follow me on YouTube
------------------
Learn Electronics Repair
https://www.youtube.com/channel/UCFX...R8UZ2vg/videos -
Re: Asus Maximus VI Gene - error code 00
o.Last edited by Aliencomputres; 09-11-2019, 10:49 AM.Comment
-
Re: Asus Maximus VI Gene - error code 00
And the reset switch is disconnected?
OK. So next thing, what voltages do you have on the motherboard?Follow me on YouTube
------------------
Learn Electronics Repair
https://www.youtube.com/channel/UCFX...R8UZ2vg/videosComment
-
I am currently working on my Crosshair VIII Hero mainboard on which a GPU short occured after which the mainboard would not turn on again. I suspected the VRM Controller (IR35201) and soldered it off. After that the board turned on again, obviously without providing voltage to CPU etc. I soldered a new IR35201 on it but it seems like the board still don't want to boot correctly. LEDs etc. turn on normally and after I press start button the power supply turns on fully and stays on, so I guess no shorts. Also nothing gets really hot. The error code shows code 00 and I measured VCPU and it was 0... -
Hi
I have an ROG MAXIMUS XII HERO (WI-FI) board with demaged PWM controller ASP1405I, and this is unfortunalely a programmable chip.
Without programming it, it won't start to work on the board - have checked this physically with a new unprogrammed chip.
I'm looking for information about the possibility to readout and program the ASUS PWM chip ASP1405I again with the firmware (configuration file).
To do this, it is necessary to buy a quite expensive I2C type interface card (named USB005), so I'm wondering if it is worth to spend the money, as this makes... -
Can't seem to find anything on this. Any help is very appreciated!09-09-2024, 11:04 AM -
Hi,
I have a 2014 vintage Philips 60PFL8708S/12 that suddenly died in the middle of the kids watching a show.
The relevant service manual for the chassis is available here.
The TV no longer powers on, and leaving it powered on for a few minutes results in the layer-1 error with 2 blinks.
When I short the SDM to ground I get the layer-2 error code 53.
The inside of the TV has no damaged components and no swollen capacitors.
In SDM-mode when all the power rails are left on despite entering the protection mode, I tracked down and measured... -
I want to make the board be compatible with 8/9 gen and want to see where socketok is on the boardview.
Comment