Hi guys, got a MSI Delta-L Mobo from a formwe unknown overclocker guy. I tried to boot with J10 Jumper in Safe Mode. I get these card reader codes : quick C1-C0 and it halts on AA :"Scan for F2 Key Stroke" , it is very early (same error w/o ram, agp) , could be a bad bios flash? . If i try to boot it without safe-mode jumper, i only get FF error. I'd really need this board. Thanks
Announcement
Collapse
No announcement yet.
"Scan for F2 Key Stroke" early init. halt
Collapse
X
-
Re: "Scan for F2 Key Stroke" early init. halt
Why would you need to desolder the capacitors and coil to change the FET?
Assuming it's SMD - use hot air to remove the FET, hot air to put the new one on. Put tape\foil or something for a heat shield around the capacitors etc if you need to."Tantalum for the brave, Solid Aluminium for the wise, Wet Electrolytic for the adventurous"
-David VanHorn
Comment
Comment