Benq Zowie RL2755 imagem partially bad

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • BMCappelletti
    Senior Member
    • Nov 2021
    • 148
    • Brasil

    #1

    Benq Zowie RL2755 imagem partially bad

    Hi everyone.
    Does this look fixable to you?
    I don't see any blown capacitor or something that stands out.

















    It's not a 4k monitor, but still a good 27' fuull HD one.
    Any help is much appreciated.
    Thanx.
  • BMCappelletti
    Senior Member
    • Nov 2021
    • 148
    • Brasil

    #2
    Re: Benq Zowie RL2755 imagem partially bad

    Actually, the issue seems to rely in one of those ribbon cables.



    I just need to figure out how to remove the LCD from that metal housing without too much force.

    Comment

    • VonMort
      New Member
      • Jul 2022
      • 1
      • USA

      #3
      Re: Benq Zowie RL2755 imagem partially bad

      Any chance you can tell me how the back comes off of that monitor?

      I need to get into one but cannot find anything on how the back comes off.

      Comment

      • BMCappelletti
        Senior Member
        • Nov 2021
        • 148
        • Brasil

        #4
        Re: Benq Zowie RL2755 imagem partially bad

        Originally posted by VonMort
        Any chance you can tell me how the back comes off of that monitor?

        I need to get into one but cannot find anything on how the back comes off.
        Hi.
        Just start removing the bezel, as you do on most monitors. The bezel is clipped to the back part. That's how I did it. The only screw I removed was the stand one.

        Comment

        Related Topics

        Collapse

        • seppde
          Benq Zowie XL2540K / Power board failure / 6Pin-SOP-Chip identification
          by seppde
          Hello everyone,
          I've got a Benq power board of a XL2540K monitor which suffered from a power cut and is since defective / won't turn on. It's got obvious defects, some blown resistors, some burning around the drain pin of a MOSFET...
          ... and some 6-pin IC I struggle identifying, that is driving said MOSFET.
          The IC is labeled as IC601, so someone with a circuit schematic could probably identify it really quick, unfortunately I can't find the schematics.
          In other power boards of Benq for which I did find the schematics, IC601 is an 8-pin NCP1200 PWM controller - I suppose...
          02-09-2024, 05:19 AM
        • gumball
          BenQ GW2450HM - Panel is partially dimmed, works for 2 hours after replacing few caps
          by gumball
          Issue: Panel is partially dark or dimmed, left side is okay (see photos attached).

          Trial: Replaced three visibly bad capacitors on the power supply board (see photos).

          First result: Monitor worked for two hours only. Two capacitors bulged again.

          Diagnosis: After replacing those capacitors the monitor was connected via HDMI cable to a laptop. Laptop was connected to power supply and charging. Power cable was removed from the laptop end and put back. Maybe this was a coincidence but since unplugging the power cable it was noted that the panel had darkened...
          10-10-2022, 01:54 PM
        • AJ847.63e
          BenQ TH681 Originally overheating now wont fire the lamp - Colour wheel not starting
          by AJ847.63e
          Hi All.

          Does anyone have any reference materials or something I can use to try troubleshooting a BenQ TH681? Google unfortunately has turned up zip. I did find a service manual for a W series BenQ but that is pretty much useless, it's more a glorified user manual. A list of voltages would be great as I suspect my mainboard is faulty, the colour wheel voltage is not dipping like it should.

          The one I am troubleshooting now was originally overheating after a lamp replacement. It originally would take 2 minutes or so for it to shut off and blink the temp and lamp lights...
          09-18-2023, 06:42 PM
        • ChatBTC
          Benq EX3501R
          by ChatBTC
          Hi!

          I am new to this site, and found it via LLM ChatGPT.

          I got a BenQ Ex3501R monitor which i have had for a while now, it works pretty good until recently, it struggles to turn on, i can see the purple welcome screen is shown for a brief time before it vanish again, usually it stays on for a couple of seconds before the main computer screen is shown, but image is still kept black, before i just had to turn it off and on a few times and that would leave it on, but now it takes ever longer to stabilize the image on the screen, ocasionally i can see the computer desktop...
          01-24-2025, 08:49 PM
        • Document Archive
          BenQ JoyBook S52 S53 Laptop Schematic
          by Document Archive
          BenQ JoyBook S52 S53 Laptop Schematic
          Quanta ED3...
          11-01-2024, 02:03 PM
        • Loading...
        • No more items.
        Working...