Hi, I replaced some swollen capacitors in my samsung syncmaster 216bw monitor and it powered on but i notice when i connect it to the computer the image is all out of place so i figured i just need to push the auto button but that doesn't help. it just moves the image up 1/4 of the screen and left about 2 inches the only time i can get it to line up properly is if i go into the menu and select reset image. any ideas on how to solve this problem?
-
-
Re: Samsung SyncMaster 216BW question
Check, clean, reseat every internal cable whether you touched it or not.--- begin sig file ---
If you are new to this forum, we can help a lot more if you please post clear focused pictures (max resolution 2000x2000 and 2MB) of your boards using the manage attachments button so they are hosted here. Information and picture clarity compositions should look like this post.
We respectfully ask that you make some time and effort to read some of the guides available for basic troubleshooting. After you have read through them, then ask clarification questions or report your findings.
Please do not post inline and offsite as they slow down the loading of pages.
--- end sig file --- -
Re: Samsung SyncMaster 216BW question
hi again thanks for the reply i tried what you suggested but it didnt work. what step should i take next?Comment
-
Re: Samsung SyncMaster 216BW question
In the menu system there should be a reset. Try it.36 Monitors, 3 TVs, 4 Laptops, 1 motherboard, 1 Printer, 1 iMac, 2 hard drive docks and one IP Phone repaired so far....Comment
-
Re: Samsung SyncMaster 216BW question
I already did the reset its the only way to get the screen to center at best but it the auto button thats not workingComment
-
This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-07-2024, 05:50 AM
-
This display looks a bit dim but the image is otherwise fine. I already set the contrast to 100 and the brightness to 50 (more than that is counterproductive, it becomes hazy).
To enable extra tuning, I have to enable the "Highlight Zone" function and stretch it to full screen. That way it looks really bright/intense and really good! I wish I could set it permanently like this, but as soon as you change the display mode/resolution or you turn the monitor off, you lose the "Highlight zone" config and you have to manuallly activate it again. Also, the manual says... -
hi
having problem with samsung ua55es6800
tv had backlight on, sound working - responds to the remote control but no image.
check tcon board - had 12v in but no other voltages present.
when disconnected left ribbon cable - got back voltages and half image with lines and distorsion
when leaving only left side connected - again no voltages and no image.
put a tape on all (cd?! lines) on the left ribbon cable and got complete but distorted image (horizontal lines).
kept trying to block less pins on the left ribbon cable... -
Hi folks,
I'm new here and was wondering whether you might be kind enough to give me some advice on troubleshooting the following problem:
Quite a few years ago now, a couple of years from new, my Samsung Syncmaster 740BF LCD monitor starting playing up by making a buzzing noise and then the display would go blank. I seem to remember the blue power led would also go off when this happened but that I'm not 100% sure of. By pressing the power button I do remember I could at first get it working again but eventually the problem would come back. At the time I had read about... -
This specification for the Samsung Galaxy Book Ion NP950XCJ Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the NP950XCJ boardview and NP950XCJ schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-06-2024, 11:40 PM
Comment