Hello, This lcd works fine except for 1 bright thin vertical line on the right hand side, about 3" in from the side.
It runs from top to bottom, and has some color to it.
I tried some preasure tests to the ribbon at the top while it was turned on, but this didn't have any effect at all.
The location of the line is not directly below any of the tape bond connections, but in between two of the bonds.
I suppose this rules out delamintation of the tape.
Would a live pixel exerciser program work on this? or should I give up and put up with the thin line?
Thanks for any advice in advance
Kind Regards:Andy.
It runs from top to bottom, and has some color to it.
I tried some preasure tests to the ribbon at the top while it was turned on, but this didn't have any effect at all.
The location of the line is not directly below any of the tape bond connections, but in between two of the bonds.
I suppose this rules out delamintation of the tape.
Would a live pixel exerciser program work on this? or should I give up and put up with the thin line?
Thanks for any advice in advance
Kind Regards:Andy.
Comment