Westinghouse 22w3 Troubles

Collapse
X
Collapse
+ More Options
Posts
 
  • Time
  • Show
Clear All
new posts
  • atomaka
    New Member
    • May 2011
    • 1

    #1

    Westinghouse 22w3 Troubles

    A little over a year ago, my Westinghouse 22w3 stopped functioning. Initially, the screen started acting, but shortly after, it stopped powering on at all. I finally got around to replacing the capacitors on the board a couple of months ago. The monitor worked correctly for a month before it stopped powering on again. The caps look fine and I can't imagine them going bad already so I'm looking for any suggestions for what the issue could be.

    Thanks!
  • FIXITNOW
    Senior Member
    • Jun 2008
    • 128
    • UK

    #2
    Re: Westinghouse 22w3 Troubles

    what type and version of caps did you use where they low esr ?

    Comment

    Related Topics

    Collapse

    • Seville
      Westinghouse TV WD48FAB100 Not Powering On – Burn Mark Found on Power Supply
      by Seville
      Hello all!

      Westinghouse TV WD48FAB100 Not Powering On – Burn Mark Found on Power Supply .

      I have a Westinghouse LED TV, model WD48FAB100 that is not powering on. Upon removing the back cover, I noticed a burn mark where the AC cord connects to the power supply/main board. In this model, there is only one board combining the two functions. Previous owner said the TV experienced a lightening strike, but who knows. I checked the main fuse, tested OK. Here are a collection of readings from the power supply ports. Looking for some guidance on what to test/check next....
      10-10-2022, 07:31 AM
    • flat-earther
      HP F4180 stopped working please help troubleshoot
      by flat-earther
      I was doing a large print job with my HP Deskjet F4180, and after about 50 pages the printer stopped in the middle of a page and the black ink light started flashing.
      So I went to refill the black ink cartridge with a syringe, but found out it still had a lot of ink.

      I tried to print a page again but every time it would print only a bit of the page and immediately stop with the black ink light flashing again.
      I tried two other black ink cartridges, and the problem still endured, so I knew this problem had to be with the printer itself.

      I ran HP Print and Scan...
      05-11-2025, 02:21 AM
    • valvashon
      LG 55UH6150- trouble powering up, then half lit screen (pictures!)
      by valvashon
      The 55" LG has been in the basement for a few months without being used. Turned it on yesterday, set came on as it should and showed a complete screen for about 5 seconds (was on a broadcast channel but no antenna was connected), then the screen went mostly dark with about 1/3 of the screen on the right lighting up with brighter lines in that lit part (sorry, no pictures of that). Power LED was cycling too, preventing the TV from fully powering up.
      Pulled the back off, all boards looked OK. Pulled the LED connector, turned the set on to see if it would power up but I don't belive it...
      11-24-2024, 12:08 PM
    • DarKHawK
      Asus 2021 ROG Strix G17 G713 not powering on and not charging.
      by DarKHawK
      Hi,

      I have an Asus 2021 ROG Strix G17 G713 that is not powering on and not charging. Board number is G533-6050A3250201.
      When plugged in, I found that the 3.3v/5v regulator was getting extremely hot, so I removed, next I found a short on the 3.3V rail. Removed the two 3.3v mosfets and found one of them shorted, but still the short on the rail did not clear. Then I injected voltage at that rail, and found out that U60400 the 2.5v rail was also getting hot. Removing it changed the short from 0 ohms to about 5-6 ohms, then I remove a bunch of other suspect components but that did...
      Yesterday, 05:24 AM
    • serious_electron
      Strange! Acer laptop not powering on but charging the battery (orange light on when charger and battery plugged in).
      by serious_electron
      Hello Everyone!

      I have an Acer Aspire A315-42 laptop. I generally leave it on for long time by closing down its lid (so it enters the sleep mode). Recently, it rained quite heavily in out area. And the humidity and moisture seem to be high. So one late evening, after I opened the lid and turned on the laptop, it did power on as the blue light turned on but after it booted to the desktop screen, just 5-10 seconds after both the screen and blue light went out and laptop shut down (the blue power light turned orange). And after 2-4 seconds that orange light went off and the laptop died.
      ...
      06-28-2025, 02:57 PM
    • Loading...
    • No more items.
    Working...