New to Audio equipment. Received this 7.2 Surround Sound system - had a blown channel and fixed that (0.22 ohm resistor, 2 transistors, and 1 100 ohm replaced)
All channels now work. However, when I raise the volume with knob or remote, it doesn't work smoothly - you can heard distortion, and some speakers don't seem to work at max or somewhere in between..
First thought was the actual audio switch - but then Remote volume control shouldn't have this problem, but it does.
Second thought was the ribbon cable from front display to control board (V-Flex, 29 pin Cable) was pitched in the process and repaired it for testing. Though I can't seem to find a replacement for it anywhere.
Any thoughts what to look for here?
Thanks
All channels now work. However, when I raise the volume with knob or remote, it doesn't work smoothly - you can heard distortion, and some speakers don't seem to work at max or somewhere in between..
First thought was the actual audio switch - but then Remote volume control shouldn't have this problem, but it does.
Second thought was the ribbon cable from front display to control board (V-Flex, 29 pin Cable) was pitched in the process and repaired it for testing. Though I can't seem to find a replacement for it anywhere.
Any thoughts what to look for here?
Thanks
Comment