Hi
working on a not turning on Wheelspeed WS1 scooter.
diagnosed - issue is the display/power button
on the board, with the multimeter I noticed there is a short to ground. as the red wire has 0 ohm to ground.
with infrared camera, this chip (photo circled) would heat up if I push power button on.
but I can't find any replacement or online info of this chip.
on the chip you can see it has a label GM2H, I have another good working display with the same chip but it has label GM2C
could anyone help me id this chip and guide me to mouse or digikey which chip I should get
the scooter is 36v
thanks in advance
working on a not turning on Wheelspeed WS1 scooter.
diagnosed - issue is the display/power button
on the board, with the multimeter I noticed there is a short to ground. as the red wire has 0 ohm to ground.
with infrared camera, this chip (photo circled) would heat up if I push power button on.
but I can't find any replacement or online info of this chip.
on the chip you can see it has a label GM2H, I have another good working display with the same chip but it has label GM2C
could anyone help me id this chip and guide me to mouse or digikey which chip I should get
the scooter is 36v
thanks in advance
Comment