hello guys, got a nas synology with motherboard DDM21L 1P to fix
this one take storm...damn, after that hdd dies but the nas can boot fine
it works only on 10bmps and not switches to 1000mbps
on look, there is no burnt areas, no resistor burn and can't find any short.
i look in the datasheet of the marvell ehernet controller : 88E1512 but i don't understand how it works.
i think TX_CLK control the connection speed but not sure of that.
do you know if i can block (by jumpers for example) the speed of this crap ?
thank you
this one take storm...damn, after that hdd dies but the nas can boot fine
it works only on 10bmps and not switches to 1000mbps
on look, there is no burnt areas, no resistor burn and can't find any short.
i look in the datasheet of the marvell ehernet controller : 88E1512 but i don't understand how it works.
i think TX_CLK control the connection speed but not sure of that.
do you know if i can block (by jumpers for example) the speed of this crap ?
thank you
Comment