Hi all,
I've been given a Logitech Z5500 set and reported that it sometimes had distorted/garbled digital audio and also that the slow-blow fuse in the amp blows once in a while.
I've opened up the controller and most things look fine, although I'm suspicious of a few solder joints.
I was going to re-cap, but after a quick PM with Th3_uN1Qu3 he suggested that might not be worthwhile.
Rather than bombard him with PMs, I thought I'd start a thread. He suggested some resistors might be out of tolerance, but I'm not sure where to start.
Attached front & back photos of the control pod, if they're not good enough, let me know.
Thanks,
Sean.
I've been given a Logitech Z5500 set and reported that it sometimes had distorted/garbled digital audio and also that the slow-blow fuse in the amp blows once in a while.
I've opened up the controller and most things look fine, although I'm suspicious of a few solder joints.
I was going to re-cap, but after a quick PM with Th3_uN1Qu3 he suggested that might not be worthwhile.
Rather than bombard him with PMs, I thought I'd start a thread. He suggested some resistors might be out of tolerance, but I'm not sure where to start.
Attached front & back photos of the control pod, if they're not good enough, let me know.
Thanks,
Sean.
Comment