Hi!
I would like to know which one is better for cleaning up soldering flux from pcb after soldering?
One option is 99.8% isopropyl alcohol
Other option is 70% isopropyl and 30% ethanol mixed together solution.
And also what would be the process? Do I just put it on pcb and let it evaporate or should I wash this off once it absorbed all the flux?
I also read that isopropyl is bad for pcb, but I am not sure what to think of it or what other alternative to use in that case?
I would like to know which one is better for cleaning up soldering flux from pcb after soldering?
One option is 99.8% isopropyl alcohol
Other option is 70% isopropyl and 30% ethanol mixed together solution.
And also what would be the process? Do I just put it on pcb and let it evaporate or should I wash this off once it absorbed all the flux?
I also read that isopropyl is bad for pcb, but I am not sure what to think of it or what other alternative to use in that case?
Comment