Hi Pedro, thanks for answering. I don't know what the OP is. I was going to buy it and share it, and Bastien already shared it. Thank you very much, Bastien, and you too, Pedro.
Best regards and thanks.
Best regards and thanks.
-
-
OP stands for Original Poster, that is the person who started the threadOriginally posted by firulilla
Glad you got the files anyway
My YouTube channel - https://www.youtube.com/channel/UCiD...5d6OgizDqoi_SAComment
-
Hello,
This special tool from Apple is used to recover data from Macbook A1706. I've been using it for a while but it stops working. When connecting Thunderbolt 3 between the tool and working Macbook, Macbook should prompt "new device detected, allow or not"... but it doesn't.
Has anyone ever experience this ? It's not a cabling or power supply issue, some IC have stopped working but not sure which one. Probably the one that manager thunderbolt 3
Thanks
Claude... -
Hello Gentlemen,
I am working on an apple MacBook A2442 board pn 820-02098-A with a visible short on the PMIC U7700 MVK-PLUS as per the schematics
I have a donner board from apple macbook pro m1 A2338 PN 820-02020 and I saw that the PMIC U8100 TMLT46B0-JPE could be a possible replacement for the U7700
Can you please help me confirm if the U7700 can be replaced with U8100 ?
APL1098 is it the same as APL1096
Thank you very much in advanced
Ahmad -
Hi there,
I'm looking for anyone who might have information on Apple's embedded Apple Watch charging daughterboard, ID 820-02601. This is currently used by Anker in their Apple Watch charging products, but likely by other Apple partner brands as well.
You can see the board referenced in ChargerLab's teardown of the Anker Y1811 3-in-1 MagSafe cube - they discuss the "Apple Watch wireless charging circuit" about 2/3rds down the page. It's not pictured, but the board ID reads 820-02601-A, which sure sounds like Apple.
This daughterboard uses an interesting...04-21-2025, 11:41 PM -
Hi Dear Friend., I am working on a Apple MacBook Pro A2338 820-02773-A. The history was that the AON Rail on the Trackpad connector JT400 was burnt. After I removed the burnt connector, I tested with the meter & no shorts. Connected the USB C power & all booted fine, no problems at all. I soldered a New TP connector put in the old trackpad with a brand new Flex cable. The laptop beeped in the start but no display. I removed the connector & the display was fine again. USED a known good Trackpad & a Flex cable, even with this still the same problem. I checked the connector whether... -
Hello! I'm looking for schematics (Boardview & Schematic) for MacBook Pro a2991 820-02917-05. Does anyone have it? Thanks in advance06-10-2025, 07:04 AM
Comment