Hey guys,
Got a 22" belinea 0. display,Its been in the loft/attic for a while,In its original box & wrappings all sealed up..it was working when it went up and now its not.
I first switched it on and the green light,and the screen were flashing very quick..then i turned it off and tried again...nothing,No lights.
So i open up the back to take a look inside (for bulging caps etc) they "Visually" look fine,I have replaced the T2 5Amp fuse on the PSU board...plugged it in and tried again,The green light flashed once and that was it..nothing again.
It gets VERY cold during the winter and quite warm (in the summer) up in the loft/attic ,could this have killed/dried out the caps?
Ive noticed they used HERMEI,Think replacing them with United Chemi-Con or Panasonic of the same values woud fix this monitor?
Got a 22" belinea 0. display,Its been in the loft/attic for a while,In its original box & wrappings all sealed up..it was working when it went up and now its not.
I first switched it on and the green light,and the screen were flashing very quick..then i turned it off and tried again...nothing,No lights.
So i open up the back to take a look inside (for bulging caps etc) they "Visually" look fine,I have replaced the T2 5Amp fuse on the PSU board...plugged it in and tried again,The green light flashed once and that was it..nothing again.
It gets VERY cold during the winter and quite warm (in the summer) up in the loft/attic ,could this have killed/dried out the caps?
Ive noticed they used HERMEI,Think replacing them with United Chemi-Con or Panasonic of the same values woud fix this monitor?
Comment