Re: Viewsonic VX2235wm-5 _ Will not power up.
OK......T3.15A 250CQ.....The AC cable goes right over it and I would never have seen it without the nice bright sun outside and a headband magnifier....Unfortunately I think the board position # is covered with a white gue but there is a T103 nearby ..But that may refer to the next component ....However ? and I hope I am correct here ..there is no way I can actually measure the fuse (s) with a multimeter unless I take the Power Board off ....and I presume that if I take the four screws out ,the board will lift off and disconnect itself from the circuit board ....If I am correct is there anything to be wary of before I do this ....and if there is could I please be advised... I can then do the fuse check etc and post the results ...Thanks
OK......T3.15A 250CQ.....The AC cable goes right over it and I would never have seen it without the nice bright sun outside and a headband magnifier....Unfortunately I think the board position # is covered with a white gue but there is a T103 nearby ..But that may refer to the next component ....However ? and I hope I am correct here ..there is no way I can actually measure the fuse (s) with a multimeter unless I take the Power Board off ....and I presume that if I take the four screws out ,the board will lift off and disconnect itself from the circuit board ....If I am correct is there anything to be wary of before I do this ....and if there is could I please be advised... I can then do the fuse check etc and post the results ...Thanks
Comment