Hello All,

tl;dr: minimal electronics experience and my first repair, lifted 8 pads off the laptop display LED controller board when attempting a connector replacement, options are attempting pad repair or jump wiring.

Laptop Model: MacBook Pro 15 Mid-2014 Retina, A1398 MGXA2LL/A
eDP Display: Samsung LSN154YL01-A02, assembly sold as Apple part 661-8310
Soldering Equipment: Hakko FX-888D w/ T-18 tips (Chisel, Conical, Bevel types)

I needed to replace the 30-pin I-PEX Cabline connector (labeled J8300 in the Apple 820-3662 mainboard schematics),...

Hi everyone,

I've got a rx580 Sapphire Pulse stopped working while I was playing a game.
Since then, when I turn on my computer, the fans are spinning but the card is not recognized (no display neither). The GPU core is heating when turned on. I'm a noob in electronic and I followed some youtube stuff but no luck for now.

I wrote down what I found (see the pictures) and I got a strange behavior on the APW8722A, on the top left. The VCC pin (the 5th) has 0V and 0 Ohm when the card is powered up.
According to the APW8722A datasheet, from a second APW8722A...

Hi guys
I've been getting more air con controller boards of various brands for repair - mainly the ones from the outdoor compressor unit and I realise I have a lot of gaps in my specific knowledge, while being pretty good at electronic repair in general.

Does anyone know of any good resources for information on this sort of repair? I'm hoping here there will be some guys who are experienced in this. I'd specifically like more info on how the controller PCB works, because I expect they are all pretty much the same, and especially how it communicates with the indoor unit (protocols,...

Hi guys,

If someone would be able to provide some expertise, I'd be very grateful.

BIOS Corruption - Cause
So I managed to corrupt my machine by installing linux and enrolling custom secure boot keys. I did choose to enroll the Microsoft keys as well, to prevent any potential bricking due to 3rd party drivers from HP being signed with those keys.
After doing that, and rebooting(it did boot, powerLED, fanspin etc.), the laptop did not give any video output on the LCD or video connectors. I think I was able to get in BIOS and trigger the beeper by pressing ESC....

trying to fix a MSI RX580 Gaming X Plus 8GB

resistances all look normal there are no shorts on any of the rails the card powers on and all voltages are present except v core not sure where to go from here any help would be appreciated

Its uses GS7256 for memory and memory controller
https://cdn.badcaps-static.com/pdfs/...3cb0d60647.pdf

These are the voltages i got from memory
Pin 1 = 9.2
Pin 2 = 9.25
Pin 3 = 1.95
Pin 4 = 8.84
Pin 5 = 11.98
Pin 6 = 0.60
Pin 7 = 1.24
Pin...