Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Ok, It's better not to do it anymore, the problem is in the panel itself. There are two options, either this or replacing with a new panel.
Hitachi 58HK6100U LED TV - Sound but No Picture
Collapse
X
-
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Well then leave from 2 to 14 inclusive.Leave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
To be honest, I think that is the best its going to get.
I have tried reducing from 14, one contact at a time, and it doesnt get any better. Anything from 12 or less looses pictureLeave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Try different combinations, where it will be better, and leave it.Leave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
From 2 to 14 inclusive, I get picture, but with aot of thin black horizontal lines, and a weird patch in bottom left cornerLeave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Until 19, this is a lot you have glued, from 2 to 9 (inclusive) and up to 14 (inclusive) try
1 does not need to be isolated, this is VGH, you need it.
In general, you need to experiment with these contacts, you can achieve a normal picture if you're lucky.Last edited by lotas; 09-03-2022, 07:52 AM.Leave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
I have covered from 2 to 19, and have picture, although a bit grainy, but no vertcal lines this timeLast edited by Bloopeta; 09-03-2022, 07:14 AM.Leave a comment:
-
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
So do I cover these numbers on cable with tape?Leave a comment:
-
-
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
I see, I will try that, thankyouLeave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Here it is necessary to experiment with these contacts, try both 14 and 15, 16, also try to isolate them in turn ...
This microcircuit is responsible for these signals, and you have damaged drivers on the one hand, which must be isolated.Last edited by lotas; 09-03-2022, 03:26 AM.Leave a comment:
-
-
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
Ill try againLast edited by Bloopeta; 09-03-2022, 02:30 AM.Leave a comment:
-
Re: Hitachi 58HK6100U LED TV - Sound but No Picture
They glued something wrong, the second photo is about how to glue it, but you need to glue (isolate) these contacts.Last edited by lotas; 09-03-2022, 02:25 AM.Leave a comment:
Related Topics
Collapse
-
by iglitareHi,
i want to repair a Sony KD-75XF9005 TV that initially only showed a grey picture.
Backlight seems to work, Sound (Setup menu after reset) works.
If i dissconnect the left FFC cable from TCON to panel i have half a screen on the right. If left cable is connected always only the grey screen.
Interchanged the cables, its always only the right side that is working. Always grey if left side is connected.
With my small knowledge i would think at least the cables are good.
Can this happen because of a bad tcon board?
Or is it always a bad/shorted... -
by KYBOSHPicked up a bahemoth plasma TV not too long ago and just now getting around to looking at it.
No picture but you hear the TV static (white noise) playing loud and clear.
The back was already taken off (and no screws were provided) as the previous owner had already taken a look.
But it seems they didn't get too far and just left it.
When I first took a look I was amazed at how pristine the inside looked.
Its as if the TV had been in a time capsule.
Caps looked like they were just pulled off the self.
Copper coils had no sign of corrosion on... -
by TR103Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
by IerwinHello everyone,
Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
Anyway I still fully expect that there has been something seriously damaged... -
by jchangHi all
I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.
Symptom:
No picture no sound.
When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
No sound at all.
What I tried:
1. I tried unplugging the left or right ribbon... - Loading...
- No more items.
Leave a comment: