Hello,
Please can Tl886ll plus program emmc?
Please can Tl886ll plus program emmc?
-
Samsung UN58MU6070FXZA LED TV Part List...10-12-2024, 11:59 AM
-
Hi There!
I'm trying to help my friend who owns a restaurant be just bought.
He has a very long LED strip running along all the walls and columns. The strip is attached facing down 2in above the floor, using a wall panel that ends in a metal rail that finishes the panel underneath
It's stuck using, I guess, the 2 sided tape that comes with the strip
The issue is that like 1/2 of the full length, including 1/2 one wall, another entire wall, and one column, flickers after 4 or 5 minutes ON. Particularly it flashes staying OFF most of the time and flashing ON for 1 tenth... -
So My iPad was not charging and booting up . i went to a local technician and he checked with thermal and this Part marked in 1st Photo is Short.
So then i went on to boardview and downloaded the schematics and identified this part in 2nd Photo. Now i am confused what exactly is the part called ? where should i get this from ?
i contacted my technician and he sent me his BoardVIew screenshot in 3rd Photo. In his Boardview the part is called X2826.... Something
SO My main concern is what part should i order what should i search the name for ?
on Ipad... -
Hi,I have damage on BN44-00598A.
I need two mosfets 13NM60N and ic SEM3040 but other damaged unknown part is:
QP805
RP849
DP805
DP806
DP807
RP848
QP804
Thanks.01-18-2025, 08:35 AM -
Hello all,
help needed.
I want to made backup of boot and all partitions from emmc desoldered from old phone.
So i have wired emmc directly to RT809h - Dat0, GND,CMD, CLK, VCC, VCCQ - on programmer sw set Smart Identify to EMMC ISP and voltage to 3.3V.
In Settings (N) i have set area to user, boot1,boot2 and EXT and vccq set to 1.8V (tested 3.3V too).
Problem is, that i still get Read Timeout Error
OK - emmc can be dead...so i have tested emmc wires connection to micro SD adapter and then in card reader and emmc was detected.
So...01-16-2025, 04:34 PM
Comment