SOVOS Flip down TV SVKTV156A

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • barry wilkins
    Senior Member
    • Aug 2009
    • 172

    #1

    SOVOS Flip down TV SVKTV156A

    Hi has any body got any info on this LCD TV?
    Something is dragging down the 12V power supply ,looks like a severe overload

    thanks

    Barry Wilkins
  • zens electronics
    Member
    • Jan 2021
    • 31
    • uk

    #2
    Re: SOVOS Flip down TV SVKTV156A

    Hi Barry

    With the TV disconnected from mains , carry out a continuity test from GND to the 12 V rail .

    If low , the method i use for quick diagnosis , would be to diconnect source of rail , then feed in a low supply to start with , maybe a few volts from an external bench supply , obviously with TV still off .

    If current draw ramps up quite considerably as you gradually start to increase supply , then check to feel which component is running very hot .

    I normally cover the board with freeze spray , as it's easier to spot which component begins to heat up .

    Comment

    • barry wilkins
      Senior Member
      • Aug 2009
      • 172

      #3
      Re: SOVOS Flip down TV SVKTV156A

      Hi it is not mains driven ,it has a 12volt power supply , as I am not much up on LCD tvs ,beginning to think it could be the back light.
      So I will take a look at that.

      Barry

      Comment

      • zen
        Badcaps Veteran
        • Apr 2011
        • 511

        #4
        Re: SOVOS Flip down TV SVKTV156A

        Hello again Barry

        Have you tested TV with another power supply .

        Had these types of supplies , give up under load .

        Comment

        • barry wilkins
          Senior Member
          • Aug 2009
          • 172

          #5
          Re: SOVOS Flip down TV SVKTV156A

          I tried another 12 supply it still shut down.
          I think this has been repaired before, the capacitors on the board are normal type and have been glued down .they are far too big ! .
          Looked like a burn up under this lot,when I managed to remove this mess I could see the capcitors should have been surface mounted type ,which are much smaller.
          There was a component on the board that looked very poorly I could not determine what is was,, it measured a couple of ohms.
          I powered the board up today and it started to burn up ,what I had been looking at was a surface mounted capacitor,quite a bit of damage to the board so a bit of work to fix it.
          There are two surface
          Barry

          Comment

          • dick_barton
            Badcaps Legend
            • Aug 2015
            • 6642
            • Wales

            #6
            Re: SOVOS Flip down TV SVKTV156A

            Post some photo's. It could be helpfull.
            Willing to help but I'm no expert.

            Comment

            • Diah
              Badcaps Legend
              • Feb 2013
              • 6363
              • Germany

              #7
              Re: SOVOS Flip down TV SVKTV156A

              Originally posted by dick_barton
              Post some photo's. It could be helpfull.
              Originally posted by barry wilkins
              ...
              you know what.. i would like to encourage any one with less sources of equipment's to put his hand on the first PC power supply he got before or later.. they will give you enough watts of any line we need 3.3V & 5V &12V. so all in one,

              Comment

              Related Topics

              Collapse

              • Tynan Dill
                Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
                by Tynan Dill
                I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

                Upon bringing it home and plugging it up, it showed a standby light.

                I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

                The screen seems to blackout and stay black, but with a flashlight I can see the display.

                With my Playstation 4 connected via HDMI, and running a game I can hear sound.

                Assuming...
                11-22-2024, 01:46 PM
              • sam_sam_sam
                Desoldering gun station modified to use a 18 volt @ 20 amp switching power supply
                by sam_sam_sam
                I have wanting to do this project for quite sometime now and I finally found a switching power supply that will work on this desoldering gun station ZD-915 that the original switching power supply took a shit and just was not worth trying to fix it because this switching power is not quite big enough to handle the heater element and the vacuum pump

                One note when I tested the switching power supply and the voltage control board I noticed that this desoldering gun heat up much faster than the original switching power supply which I was really surprised by to the point that I might buy...
                03-31-2024, 02:12 PM
              • Document Archive
                MSI Summit E13 Flip Evo E13 FLIP EVO A11MT-018AU Hybrid (2-in-1) Specification for Upgrade or Repair
                by Document Archive
                This specification for the MSI Summit E13 Flip Evo E13 FLIP EVO A11MT-018AU Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the E13 FLIP EVO A11MT-018AU boardview and E13 FLIP EVO A11MT-018AU schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties...
                09-07-2024, 04:10 AM
              • Document Archive
                MSI Summit E16 FLIP EVO A13MT-262BE Notebook E16 Flip Evo Specification for Upgrade or Repair
                by Document Archive
                This specification for the MSI Summit E16 FLIP EVO A13MT-262BE Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the E16 FLIP EVO A13MT-262BE boardview and E16 FLIP EVO A13MT-262BE schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...
                09-07-2024, 06:38 AM
              • Document Archive
                MSI Summit E16 FLIP A13VFT-020BE Hybrid (2-in-1) E16 Flip Specification for Upgrade or Repair
                by Document Archive
                This specification for the MSI Summit E16 FLIP A13VFT-020BE Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the E16 FLIP A13VFT-020BE boardview and E16 FLIP A13VFT-020BE schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...
                09-07-2024, 06:38 AM
              • Loading...
              • No more items.
              Working...