Kdl-46s504

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • engelwood39
    Senior Member
    • Mar 2015
    • 93
    • United States

    #1

    Kdl-46s504

    I have a Sony TV that when I turn it on the backlighting comes on and the green power LED comes on however I have no picture or no sound as I cycle through inputs. Any ideas on where I should start?
    Attached Files
    Last edited by engelwood39; 11-07-2017, 10:31 PM.
  • engelwood39
    Senior Member
    • Mar 2015
    • 93
    • United States

    #2
    Re: Kdl-46s504

    Here is the voltages on that plug
    Attached Files

    Comment

    • dick_barton
      Badcaps Legend
      • Aug 2015
      • 6642
      • Wales

      #3
      Re: Kdl-46s504

      Locate the surface mount fuses marked on the mainboard and check they are not open circuited.
      Attached Files
      Willing to help but I'm no expert.

      Comment

      • Andrew F. Ali
        Badcaps Legend
        • Jan 2014
        • 2450
        • Trinidad & Tobago

        #4
        Re: Kdl-46s504

        Are those the actual voltages you measured and recorded off the board??

        Comment

        Related Topics

        Collapse

        • meraklinetx
          Asus Z97-a power cycle, no boot no cpu voltage
          by meraklinetx
          Hello, I have an asus Z97-A motherboard and it doesn't start which was working properly before, the problem isn't related by ram, ram slots or psu (I changed all and nothing work), the exact problem is when you switch it on , it starts and after 1 seconds (no boot or display picture) it's off and then on cycle continuously until you power it off from psu also it's responding to the power switch for turning it off if you keep pressing it 3 or 4 seconds (power button pin has 3.3v) , also when you start it with eatx 12v socket connected this is happening (power cycle also all voltages are resetting...
          05-10-2023, 06:08 AM
        • nono34
          Hisense stuck in Colors cycle like test pattern.
          by nono34
          Hello,

          I accidentally changed the project ID in the service menu of my Vidaa Hisense 100U7KQ TV. When I turn on the TV, the screen displays an RGB color cycle (test mode???). I contacted Hisense, and they sent me a usb_MTK_9618.EU.bin file, but it doesn't work. I can see that the USB drive is being read, and it flashes for about 10 minutes (the screen remains in the color cycle during the firmware reading), then the TV turns off and restarts, but still in the color cycle mode.

          I want to mention that the 4GB USB is formatted in FAT32 MBR. I've also renamed the file to...
          10-24-2024, 04:31 PM
        • Yoda79
          Samsung ue55nu7021k Boot cycle
          by Yoda79
          Hi, wondering if anyone can help with a tv which seems to turn on but turn off soon after and continue to do this cycle over and over again.

          It turns on, no sound and then turns off and starts the whole cycle again. I've opened up the back and can see the backlights turning on. However when I disconnect the two straps connecting the left hard board (as you look on the back of the TV), the boot cycle stops and it does turn on and I can hear the boot up sound, however no video?

          Any thoughts, any help would be greatly appreciated.​...
          06-30-2024, 03:43 PM
        • willoriker
          motherboard power cycle MAX VI Gene
          by willoriker
          hi to everybody
          i have a asus maximus VI gene with a power cycle, i made a lot of diagnostic, but i could found the problem
          i check power sequence, all power source ( 5. 3.3 1.5 1.05, 3.3 cpu vmr) every is ok
          without accesories ( no proc no ram nothing) mother start and keep working
          when i insert cpu, mother boot up, post secuence start .. for 4 second post card show tipical info, and the power cycle begin.
          some behavior . start post and restart. i test, replace bios with difernte version..... NOthing
          try difernt powe supply, porcessor, anbd memories....
          05-16-2023, 03:34 AM
        • spice_disc
          Vizio TV M50-C1 reboot cycle and static on screen
          by spice_disc
          I'm currently trying to diagnose and fix my Vizio TV (Model M50-C1). I've tried a number of different basic solutions, but I'm trying to determine if my issue is currently a failing panel, T-Con board, or main board (or something else entirely) and whether or not it is worth my time to fix it. Details of the issue and what I've tried are below as well as why I think it is either a bad panel, T-Con board, or main board.

          The Issue: The TV will be on and working fine but after the TV is on for ~5-10 minutes the screen will freeze (with sound continuing) until the TV reboots itself. While...
          09-08-2024, 02:37 PM
        • Loading...
        • No more items.
        Working...