Tv experiencing issues whilst in PC and DTV modes whereas the OSD Menu only stays on the screen briefly
If I follow the following procedure on the above named TV it just shows a blue screen with the 'S' service menu icon top right corner, does not show any 'Menu' options.
'TOSHIBA
1.
# Turn the TV on.
# Press the {MUTE} button three times on the remote.
# Press the {MUTE} button again on the remote and hold.
# Then press the {MENU} button on the TV's front panel.
# Release both buttons
# There should be a letter "S" on the upper right of the screen.
# Press the {MENU} button on the TV's front panel again.'
Pressing the 'Menu' keypad button again and I can toggle between RCut,GCut,BCut,RDRV ETC... which are displayed top left corner but I'm sure I really don't want to be changing any of these.
Is the Eeprom data corrupt possibly or a faulty BGA chip on the Signal Board or am I missing something? PS bd volts all seem ok and TV operates normally otherwise, well HDMI input gives a good picture and sound and remote and keypad work.
If I follow the following procedure on the above named TV it just shows a blue screen with the 'S' service menu icon top right corner, does not show any 'Menu' options.
'TOSHIBA
1.
# Turn the TV on.
# Press the {MUTE} button three times on the remote.
# Press the {MUTE} button again on the remote and hold.
# Then press the {MENU} button on the TV's front panel.
# Release both buttons
# There should be a letter "S" on the upper right of the screen.
# Press the {MENU} button on the TV's front panel again.'
Pressing the 'Menu' keypad button again and I can toggle between RCut,GCut,BCut,RDRV ETC... which are displayed top left corner but I'm sure I really don't want to be changing any of these.
Is the Eeprom data corrupt possibly or a faulty BGA chip on the Signal Board or am I missing something? PS bd volts all seem ok and TV operates normally otherwise, well HDMI input gives a good picture and sound and remote and keypad work.
Comment