Rca 46la45rq won't turn on

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CapLeaker
    Leaking Member
    • Dec 2014
    • 8146
    • Canada

    #21
    Re: Rca 46la45rq won't turn on

    So the PSU is good. Did you have the inverter board connected when you forced the PSU on and made the 12/24V rails come up?
    Right now it seems the inverter isn't turning on, if the 12/24 rails are working and the inverter plugged in.

    Comment

    • Blndreaper
      Member
      • Jan 2017
      • 14
      • United States

      #22
      Re: Rca 46la45rq won't turn on

      Panel modle is: T460HW08 V.0
      Ok, so I reconnected just the main board and turned on power (plug going to inverter board and the 4 wire plug with the two 24v that goes to the main board are NOT plugged in) and all voltage is present without a need to jump, but if I plug in either of those 2 plugs and turn back on the psu will not turn on any 12 or 24v

      Comment

      • CapLeaker
        Leaking Member
        • Dec 2014
        • 8146
        • Canada

        #23
        Re: Rca 46la45rq won't turn on

        So there may be a short then on one of these boards... Take your DMM put it in ohms mode and check the power rails on these suspect boards between positive and negative.

        Comment

        Related Topics

        Collapse

        • Tynan Dill
          Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
          by Tynan Dill
          I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

          Upon bringing it home and plugging it up, it showed a standby light.

          I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

          The screen seems to blackout and stay black, but with a flashlight I can see the display.

          With my Playstation 4 connected via HDMI, and running a game I can hear sound.

          Assuming...
          11-22-2024, 01:46 PM
        • sam_sam_sam
          Modification to a ZD-987 desoldering/soldering station using a external switching power supply
          by sam_sam_sam
          I have been working on this concept for quite some time now with limited success but recently I found a switching power supply that is setup for the voltage that this soldering station needs to operate at however it also needs part of the secondary circuit from the original switching power because you need several voltage rails

          I once tried to get a ZD-915 desoldering station to work on a 18 volt battery power supply but unfortunately things did not go well but I did find a work around but I might try this idea again but going at a little differently more about this another time...
          07-01-2024, 06:34 AM
        • JimBanville
          Definitive technology SC 2000 subwoofer amp's power supply clicking and popping
          by JimBanville
          The sub developed a constant popping every couple seconds from woofer and power LED flickering with nothing but wall AC connected. Connecting an audio cable didn't change anything. It doesn't play but a second or two of audio in between the pops.
          Opened it up and discovered the power supply is making a faint clicking or ticking sound.
          I measured the amp's output to the woofer and it pulses up to 50mv DC to be driver. The pulses coincide with the power supply ticking/clicking.
          I measured the power supply output going to the amp board and it too has this pulsing. Voltage cycles...
          09-13-2023, 07:21 AM
        • shovenose
          Christmas Light Power Supply Question
          by shovenose
          Hi all,
          I have a cheap rainbow christmas light set off Amazon which has this little power supply that has a button to change modes. I had a white set with the same power supply that I returned but I can't find any other rainbow themed ones that don't use this setup.

          Anyway, the problem is every time you unplug them and then plug them in it reverts back to "Combination" mode which cycles through all these annoying tacky effects instead of going back to what you had selected or at least defaulting to "Steady on" which is what I want. So I'm thinking I can just...
          12-08-2023, 09:59 AM
        • burntonnerings
          Acer K272HUL blue power light but black screen, power supply is ok
          by burntonnerings
          Have had two Acer K272HUL monitors die with the same symptoms:

          - Blue power light is illuminated while the monitor is plugged in
          - Black screen (no splash screen, etc.)
          - Power button doesn't do anything

          Opened it up and checked for bad caps and components, evidence of burns, etc. - everything looks fine.

          Power supply voltages are fine.

          There are some signal lines on the power supply harness that goes from the power supply to the logic board, not sure what these should be at.

          Anyone have any ideas?...
          12-09-2023, 10:22 PM
        • Loading...
        • No more items.
        Working...