I am looking for suitable replacement LED for this LED strip, its a Celcus DLED32167HDCNTD with Vestel electronics, see below pics.
Attached Files
-
Hello,
I am not sure where exactly to put this thread, so hopefully this is the best place.
I have a USB fan that has suddenly been unable to increase its speed. It's just stuck on the first speed. This fan has 3 speed settings. Each time you press the power button, the speed of the fan should increase.
The way the button works with each press is: Speed 1 > Speed 2 > Speed 3 > OFF
Speed 2 and 3 don't currently work any more.
I suspect the issue might be with what looks to be some kind of driver IC. It is a 16-pin... -
Hello. I have Industrial Washing Machine PCB.
Customer Requested Relays Replacement.
I can't find WJ115F1 relays to buy. Looking for some help to identify possible alternative solutions.
Or any tips, on how to approach this situation.... -
My 7 channel NAD receiver has audio quality and volume issues on 2 of the channels. Sometimes they work and sometimes they don't. Sometimes they're at about half the dB level of the left channels, and then they cut out entirely. Powering off and on the receiver fixes it for a bit.
Without much experience to really know for certain, they only apparent issue I can see is with these electrolytic capacitors on the power supply. Bulging = bad, correct? I'm looking for replacements but I'm unsure what leeway I have with the temp ratings. Are there any other specifications I need to worry... -
Hello Everyone
I've spent hours looking at Chinese (mainly) websites offering replacement LED strips for backlighting monitors, TVs etc but I can't find one to replace mine.
Mine goes into a BENQ GC2870, it contains 32 LEDs and is 355mm long. It is marked E117098 94V-0 on the front and NLM144LL077BDBKALB00751R901LGA on the back. I have attached some pix in case that helps.... -
I wonder if i shorted the whole strip...where to put pos and neg to just light up a single diode...or the entire strip. The strip lit for a second...so maybe i fried it? What say you?
I have an adjustable dc power supply and was trying around 9 volts.
I have a pic of a single diode...where to put pos and neg terminals to light it up?
Pic of middle of strip..is this where i light the entire strip?
And pic of end...or does this light the entire strip?
Where to put pos and neg for single diode..multiple diodes and the entire...
Comment