Blaupunkt LCD-TV

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • thoma
    Badcaps Veteran
    • Sep 2012
    • 268
    • Germany
    #1

    Blaupunkt LCD-TV

    http://tel-spb.ru/remont-tv-lcd/

    There are a lot of exotic lcd tv names in which are the same mainboards
    like in Blaupunkt!

    Open for Example Mystery you can read on the right side the numbers of
    mainboards and a lot of schematics available!

    regards thoma!
    Tags: None
    • ReeceyBurger123
      Never Give Up !
      • May 2014
      • 7325
      • Britain
      #2
      Re: Blaupunkt LCD-TV

      Yep its called rebadging, which is where a brand name gets a company to manufacture a Pcb for their Tv or they get them to actually manufacture and build the whole Tv then they put their brand name on the front.
      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

      https://www.facebook.com/Telford-Tel...7894576335359/

        Comment

        Previous template Next

        Related Topics

        Collapse
        • caspian
          Experiences on New Laptop Mainboards
          by caspian
          Dear Forum Members,

          There are many non-authorized sellers who sell spare mainboards for laptops. The question is how do they provide these mainboards?
          It is possible that some of these mainboards were defective working mainboards that were set to be recycled in the factory, but they were sold as spare mainboards. It is also possible that some of these mainboards were defective working mainboards that were replaced by a new one so that the old one was sold as a spare mainboard.
          Defective working means the mainboard still works but it has some minor problems. In the...
          08-30-2019, 10:36 PM
        • cockalomg
          Blaupunkt blaupunkt b32she188tchd-100 no standby light
          by cockalomg
          Does anyone have a schematic for this board?
          I have no output voltages, no standby voltages.
          The fullbridge rectifier has a permanent 330V
          there is no voltage on the two large black electrolytic capacitors​
          2 Photos
          11-05-2024, 03:01 AM
        • Simplebeans
          Blaupunkt 236/2071-GB-3B-HKDUP-UK stays in standby
          by Simplebeans
          I am currently attempting to repair this television.

          Currently the television stays in standby mode (red light on the television) even after attempting to switch it on via the remote control or controls on the television itself. I have opened the television up and there was a electrolytic capacitor that looked bad therefore replaced this however this has made no difference and the same issue still persists.

          I am now thinking that this could be a EPROM issue? If yes, i have not yet been able to locate a EPROM dump for this make and model of television, if anyone can help...
          07-25-2025, 04:51 PM
        • alltvrepairs
          Backlights required for Blaupunkt 50UN265 (HK50D08-ZC56AG-01) - cannot find a source
          by alltvrepairs
          Hi,

          I am unable to locate a set of LEDs for this model. Maybe you know a better source: 4 Strips of 8 Leds per strip.

          Tried with model or HK50D08-ZC56AG-01 but no luck so far.

          Regards







          ​

          ​​

          ​

          ​​

          ​...
          07-06-2025, 08:29 AM
        • tjfs
          Blaupunkt BS723 bluetooth speaker
          by tjfs
          I am trying to fix this item, it works except I can't get it to pair. Searching online hasn't found a manual for it. I am wondering if the Bluetooth module is faulty as it works in analogue audio mode.

          The module has two rows of castellated pins for a total of 24. It uses the CSR 57F68 chip together with a flash chip for storage. The main board has an amplifier chip, stereo mixer, power supplies and a microcontroller which seems to have no markings. I think the microcontroller is working correctly and sends commands to the Bluetooth module via SPI although I don't know the protocol...
          12-24-2024, 09:47 AM
        • Loading...
        • No more items.
        Working...